Occupational Health and Safety Regulation, B.C. Reg. 296/97

Section 26.66

Bunks and stakes

Cite as Occupational Health and Safety Regulation, B.C. Reg. 296/97, s. 26.66 · last amended September 1, 2027 · read from BC Laws on November 17, 2026

The text

(1) A log transporter carrying a log load must be equipped with bunks and stakes of adequate design and construction to safely perform their intended function. (2) Bunks must be able to rotate freely upon their pivots, if designed to do so. (3) Stakes, extensions and stake cables must be installed and maintained to ensure that when the log transporter is loaded (a) the angle between the bunks and stakes at the base does not exceed 90, and (b) the angle between the bunks and the stakes and extensions above the base does not exceed the angle at which the stakes and extensions can safely withstand the maximum anticipated loads. (4) Stakes must be constructed so that (a) they can be released only from the opposite end of the bunk, (b) keeper pins are secured against unintended release, and (c) if they are over 1.2 m (4 ft) in height, springs or other mechanical means are fitted to facilitate their returning to a vertical position. (4.1) A worker must not go on bunks and trailer assemblies to raise or lower stakes and extensions unless it is impracticable to do otherwise. (4.2) If a worker must go on a bunk or trailer assembly to collapse stakes or extensions, the worker must be provided a safe means of getting on and off the bunk or trailer assembly. (4.3) Procedures must be developed and implemented for collapsing stakes or extensions during adverse weather conditions. (5) Stake extensions must be secured against inadvertent detachment from the stakes. (6) Repealed. [B.C. Reg. 20/2008, App. A, s. 39 (c).] (7) Stake cables must (a) not be made from swaged wire rope, and (b) conform to the following specifications. Bunk width Stake cable minimum diameter < 2.6 m (8 ft 6 in) 22 mm (7/8 in) ≥ 2.6 m (8 ft 6 in) and ≤ 2.9 m (9 ft 6 in) 25 mm (1 in) > 2.9 m (9 ft 6 in) and ≤ 3.7 m (12 ft) 29 mm (1 1/8 in) > 3.7 m (12 ft) 32 mm (1 1/4 in) (8) Stake and bunk assemblies must be inspected daily, and must not be used if they show signs of excessive wear. (8.1) A record of all inspections conducted under subsection (8) must be maintained. (9) Repealed. [B.C. Reg. 20/2008, App. A, s. 39 (e).]
Read the Occupational Health and Safety Regulation on BC Laws ↗

Made under Workers Compensation Act, RSBC 2019, c. 1.