Occupational Health and Safety Regulation, B.C. Reg. 296/97

Section 26.65

Cab guard

Cite as Occupational Health and Safety Regulation, B.C. Reg. 296/97, s. 26.65 · last amended September 1, 2027 · read from BC Laws on November 17, 2026

The text

(1) In this section: “cab guard” means a barrier guarding the back of the cab of a log transporter; “certified welding inspector” means a person who is certified as a Level 2 or Level 3 welding inspector in accordance with CSA Standard W178.2-08 (R2013), Certification of Welding Inspectors; “rated capacity”, in relation to a cab guard, means the maximum cargo weight that may be transported by the log transporter and shift and contact the cab guard such that the cab guard is capable of withstanding a horizontal forward static load equal to 40% of that cargo weight, with this load uniformly distributed over the entire cab guard. (2) For the protection of the driver of a log transporter, the log transporter must have a cab guard that meets all of the following requirements: (a) subject to subsection (3), the cab guard is at least 15 cm (6 in) higher than the cab; (b) the cab guard is at least as wide as the cab; (c) the cab guard has no opening large enough to permit any item of cargo to pass through it; (d) the cab guard is (i) constructed with a main supporting structure made of steel, or (ii) certified by a professional engineer as having a main supporting structure designed and constructed so that vibration and distortion generated by use of the log transporter cannot damage the cab guard; (e) the cab guard is installed in a manner that ensures that the rated capacity of the cab guard is not diminished. (3) The cab guard of a self-loading log transporter may be less than the height specified in subsection (2) (a) but must not be less than the cab height. (4) The weight of cargo that is being transported by a log transporter and that may shift and contact the cab guard must not exceed the rated capacity of the cab guard. (5) The operator of a log transporter must record the results of the inspection, made before the start of operation on the shift, of the cab guard of the log transporter. (6) A log transporter must be removed from service if there are any cracks, damage or other conditions that will decrease the rated capacity of the cab guard of the log transporter. (7) A log transporter removed from service under subsection (6) must not be returned to service until (a) the cab guard is (i) repaired, and (ii) inspected and certified to meet the rated capacity by the manufacturer, a professional engineer or a certified welding inspector, or (b) the cab guard is replaced by a cab guard that meets the requirements of this section. (8) The cab guard of a log transporter must be (a) permanently marked with (i) the name and address of its manufacturer, (ii) the model number or serial number of the cab guard, and (iii) the rated capacity of the cab guard, or (b) identified by carrying in the log transporter a copy of a letter that (i) accurately describes the cab guard, (ii) certifies the model number or serial number of the cab guard and the rated capacity of the cab guard, and (iii) has been signed by the manufacturer or a professional engineer.
Read the Occupational Health and Safety Regulation on BC Laws ↗

Made under Workers Compensation Act, RSBC 2019, c. 1.