Occupational Health and Safety Regulation, B.C. Reg. 296/97
Section 20.56
Design requirements
Cite as Occupational Health and Safety Regulation, B.C. Reg. 296/97, s. 20.56 · last amended September 1, 2027 · read from BC Laws on November 17, 2026
The text
(1) The plans and specifications for tilt-up panel erection and bracing must ensure that the load to be imposed on each lifting and bracing insert and anchor during panel lifting, moving and bracing will not exceed
(a) if a working load limit for the insert or anchor is not specified by the manufacturer, a maximum working load on the component determined by dividing the manufacturer's guaranteed minimum failure load by the applicable safety factor required by subsection (2) or (3), or
(b) if the working load limit or the manufacturer's guaranteed minimum failure load is not available, a maximum working load determined by calculating the ultimate load capacity in accordance with accepted engineering practice and the BC Building Code, and dividing this value by the applicable safety factor required by subsection (2) or (3).
(2) The minimum safety factor for cast-in lifting inserts is 2.5 except as provided in section 20.57 (5); and for lift-points secured by drilled-in anchors, the minimum safety factor is 4.0.
(3) The minimum safety factors for bracing components are
(a) 1.67 for braces, and for the uplift or sliding of an anchor slab,
(b) 2.0 for cast-in brace inserts, and
(c) 2.5 for drilled-in bolt or expansion anchors, or greater if so specified by the manufacturer.
(4) The number of lift inserts for a panel must not be less than the total weight of the panel divided by the working load limit for the inserts in pullout and in shear.
(5) The temporary bracing for a tilt-up panel must be designed to resist the greater of
(a) an unfactored design wind pressure of 700 Pa (15 psf), or
(b) wind pressure calculated in accordance with the BC Building Code based on the probability of 1 in 10 of being exceeded in any year, as listed in the Supplement to the National Building Code of Canada 1990 or as otherwise specified by the local building authority, multiplied by a pressure coefficient of 1.5.
Read the Occupational Health and Safety Regulation on BC Laws ↗
Made under Workers Compensation Act, RSBC 2019, c. 1.