Certification of Petroleum Mechanics, O. Reg. 216/01
Section 11
PM.2 certificates
Cite as Certification of Petroleum Mechanics, O. Reg. 216/01, s. 11 · current to November 11, 2026 · consolidated from August 1, 2008 · read from e-Laws on November 16, 2026
The text
(1) A person who holds a PM.2 certificate may, without supervision, install, remove, alter, repair, test, service and maintain any type of underground installation and the equipment and accessories essential to its operation and, in so doing, may,
(a) install underground tanks, including the preparation and restoration of the site, the installation of temporary vents and fill pipes and pressure testing;
(b) remove underground tanks, including the preparation and restoration of the site, draining and disconnecting the tank system and purging tanks;
(c) install petroleum transfer systems, including the preparation of lines and equipment, component assembly, spill containment and vapour recovery;
(d) repair and maintain systems for detecting leaks and monitoring tanks; and
(e) install and remove submersible pumps, dispensers and related systems. O. Reg. 216/01, s. 11 (1).
(2) The holder of a PM.2 certificate may, without supervision, install underground tanks, including the preparation and restoration of sites, component assembly, spill containment, electrical hook-up and pressure testing. O. Reg. 216/01, s. 11 (2); O. Reg. 251/08, s. 7 (1).
(3) The holder of a PM.2 certificate may assist holders of PM.1 and PM.3 certificates to perform the functions that they may perform if directly supervised by them. O. Reg. 216/01, s. 11 (3).
(4) The holder of a PM.2 certificate may, without supervision, work on any type of underground equipment that falls within the scope of the certificate so long as the holder has the required experience and time on that type of equipment and that experience and time are documented in a form acceptable to the director. O. Reg. 216/01, s. 11 (4); O. Reg. 251/08, s. 7 (2).
(5) The holder of a PM.2 certificate who fails to meet the conditions for unsupervised work set out in subsection (4) may only service and maintain the equipment under the direct supervision of a PM.2 certificate holder who meets those conditions. O. Reg. 251/08, s. 7 (3).
Read the Certification of Petroleum Mechanics on e-Laws ↗
Made under Technical Standards and Safety Act, 2000, S.O. 2000, c. 16.