Municipal Wastewater Regulation, B.C. Reg. 87/2012
Section 99
Outfall requirements
Cite as Municipal Wastewater Regulation, B.C. Reg. 87/2012, s. 99 · last amended October 27, 2025 · read from BC Laws on November 17, 2026
The text
(1) A qualified professional must design an outfall such that
(a) initial dilution zone requirements under this regulation are met,
(b) air entrapment is prevented,
(c) adequate weighting is provided to prevent movement from currents, ice or possible entrainment of air, and
(d) the outfall is protected from corrosion.
(2) A qualified professional must ensure that outfall diffusers are
(a) located at a sufficient depth to maximize the frequency that municipal effluent is trapped below the surface of the water,
(b) located to intercept the predominant current and avoid small currents that tend to move toward the shore,
(c) designed to ensure that
(i) each diffuser section will provide at least 10:1 dilution within the initial dilution zone, and
(ii) outside the initial dilution zone, discharge does not cause water quality parameters to fail to meet water quality guidelines, and
(d) designed to achieve maximum dilution in a river, stream or estuary located in the channel in which most of the water flows.
(3) A qualified professional must ensure that outfalls are located
(a) such that they are protected from wave, boat and marine activity, and
(b) at a depth of at least
(i) 40 m below mean low water in the Okanagan Basin, and
(ii) subject to subparagraph (i), 10 m below mean low water in estuaries, lakes or marine waters with a surface area greater than 100 ha.
Read the Municipal Wastewater Regulation on BC Laws ↗
Made under Environmental Management Act, SBC 2003, c. 53.