Occupational Health and Safety Regulation, B.C. Reg. 296/97

Section 9.20

Blanks and blinds

Cite as Occupational Health and Safety Regulation, B.C. Reg. 296/97, s. 9.20 · last amended September 1, 2027 · read from BC Laws on November 17, 2026

The text

(1) Unless certified by a professional engineer to provide adequate safety for the particular conditions of anticipated pressure, temperature and service, a blank or blind must be manufactured in accordance with the specifications of one of the following standards: (a) ANSI Standard API 590-1985, Steel Line Blanks; (b) ANSI Standard ASME/ANSI B16.5-1988, Pipe Flanges and Flanged Fittings; (c) ANSI Standard ASME B31.1-1992, Power Piping; (d) ANSI Standard ASME B31.3-1993, Chemical Plant and Petroleum Refinery Piping. (2) If a blank or blind is certified by a professional engineer, the employer must keep a record of its certification, location and conditions of service. (3) If required, an allowance for corrosion must be made in the design of a blank or a blind. (4) A blank or blind must be stamped with or otherwise indicate its pressure rating. (5) If a line is to be opened for disconnection or to insert a blank or a blind, written safe work procedures must be prepared and followed to prevent hazardous exposure of workers to its contents. (6) Visual indication that a blank or blind has been installed must be provided at the point of installation. (7) If required to prevent leakage, gaskets must be installed on the pressure side of blanks or blinds and flanges must be tightened to make the blanks or blinds effective. (8) If threaded lines are used, threaded plugs or caps must be used to blind the lines.
Read the Occupational Health and Safety Regulation on BC Laws ↗

Made under Workers Compensation Act, RSBC 2019, c. 1.