Occupational Health and Safety Regulation, B.C. Reg. 296/97
Section 26.24
Responsibility for falling and bucking
Cite as Occupational Health and Safety Regulation, B.C. Reg. 296/97, s. 26.24 · last amended September 1, 2027 · read from BC Laws on November 17, 2026
The text
(1) Subject to section 26.29 (3), before a tree is felled, all workers must be clear of the area within a 2 tree-length radius of the tree.
(2) Before falling or bucking starts, all obstructions to the activity must be cleared and a safe escape route to a predetermined safe position must be prepared.
(3) A tree must not be felled if it could strike any stationary or running line of any operational equipment.
(4) If it is necessary to pack or shovel snow to reduce stump height, the depth of the depression at the base of the tree must not exceed 45 cm (18 in.).
(5) The falling of a tree must be conducted in accordance with the following procedures:
(a) a sufficient undercut must be used;
(b) the undercut must be complete and cleaned out;
(c) sufficient holding wood must be maintained;
(d) the backcut must be higher than the undercut to provide a step on the stump;
(e) wedging tools must be immediately available and, unless the tree has a pronounced favourable lean, wedges must be set.
(5.1) When a tree is being felled, the tree must not brush standing trees if that can be avoided.
(6) A tree must not be used to cause another partially cut tree to fall in succession unless
(a) it is necessary to do so to overcome a specific falling difficulty, and
(b) the succession falling is done in accordance with subsection (6.1).
(6.1) The following apply for the purposes of subsection (6):
(a) only one tree may be used to cause another partially cut tree to fall in succession;
(b) only those trees necessary to deal with the falling difficulty referred to in subsection (6) are partially cut;
(c) a wedge is driven into the backcut of each partially cut tree.
(7) When a tree starts to fall, the faller and any other worker present must move quickly to a predetermined safe position, at least 3 m (10 ft.) away from the base of the tree where possible, and take cover if available.
(8) All workers must be clear of the hazard area before a tree or log is bucked.
Read the Occupational Health and Safety Regulation on BC Laws ↗
Made under Workers Compensation Act, RSBC 2019, c. 1.