Occupational Health and Safety Regulation, B.C. Reg. 296/97

Section 22.1

Definitions

Cite as Occupational Health and Safety Regulation, B.C. Reg. 296/97, s. 22.1 · last amended September 1, 2027 · read from BC Laws on November 17, 2026

The text

(1) In this Part: “caisson” means a casing sunk or constructed below ground or water level; “cut” means the series of loaded and unloaded holes that are drilled in a face to serve as the location for initiating a blast; “dump” or “tip” means an accumulation of rock fragments or other unconsolidated material formed by pushing or dropping the loose material over the crest and allowing it to come to rest without further handling; “face” means any part of an underground working where excavating is in progress or was last done; “gassy underground working” means any underground working in which there exists, or is likely to exist, an atmosphere containing more than 10% of the lower explosive limit (LEL) of naturally-occurring flammable gases or vapours, or any other gas or vapour emanating from the ground surrounding the working in concentrations exceeding the exposure limits listed in this Regulation; “percussion drill” means an air or hydraulic-driven drill that breaks by impact; “portable switch” means a movable track resting on top of a regular track upon which a train car may be diverted for passing; “probe hole” means a borehole drilled ahead of or at an angle to the heading being worked to probe for conditions that lie ahead or around the underground working; “qualified person” means a person who is (a) qualified because of knowledge, training and experience to design, organize, supervise and perform the duties for which the person is appointed, (b) familiar with the requirements that apply to the duties for which the person is appointed, and (c) capable of identifying any potential or actual danger to health or safety in the workplace; “raise climber” means a mechanical powered work platform, temporary or permanent, controlled from the cage underneath the platform, used to provide access to the face of a raise or other working area; “underground working” includes any adit, tunnel, underground excavation, chamber, caisson, raise, shaft, winze or natural entry; “underground working supervisor” means, in relation to an underground working, a person appointed under section 22.12 (2) as an underground working supervisor for the underground working. (2) Unless a contrary intention appears, the definitions in section 21.1 apply to this Part.
Read the Occupational Health and Safety Regulation on BC Laws ↗

Made under Workers Compensation Act, RSBC 2019, c. 1.