Occupational Health and Safety Regulation, B.C. Reg. 296/97
Section 21.93
General requirements
Cite as Occupational Health and Safety Regulation, B.C. Reg. 296/97, s. 21.93 · last amended September 1, 2027 · read from BC Laws on November 17, 2026
The text
(1) All material to be blasted must be covered by blasting mats in good working condition.
(2) The blast hole diameter must not exceed 75 mm (3 in).
(3) The bench height to burden ratio must be at least 2 to 1.
(4) In respect of blast holes,
(a) all blast holes must be effectively stemmed with small crushed aggregate rock or an energy confinement device, and
(b) the use of drill cuttings alone does not meet the requirements of paragraph (a).
(5) Safety fuse assemblies must not be used.
(6) When using ammonium nitrate/fuel oil, slurries, water gels or other bulk explosives, the employer must ensure that
(a) the work is conducted in accordance with recognized safe blasting practices and manufacturer's instructions,
(b) the critical hole diameter is not smaller than the minimum critical hole diameter recommended by the manufacturer,
(c) the fumes of the detonated product do not affect workers or other persons at or near the blast site, and
(d) additional precautions are taken in fractured ground and in wet holes.
Read the Occupational Health and Safety Regulation on BC Laws ↗
Made under Workers Compensation Act, RSBC 2019, c. 1.