Occupational Health and Safety Regulation, B.C. Reg. 296/97

Section 20.22

Flyform handling

Cite as Occupational Health and Safety Regulation, B.C. Reg. 296/97, s. 20.22 · last amended September 1, 2027 · read from BC Laws on November 17, 2026

The text

(1) Application drawings and any supplementary instructions for flyforms must show a step-by-step procedure for all phases of each cycle of assembly, flying, use, dismantling and reuse of each flyform panel, including special procedures for non-typical floors. (2) If any flyform panel is not inherently stable for all possible conditions of load, special notation on the flyform application drawings and any supplementary instructions must draw attention to the procedure for obtaining stability. (3) The employer must ensure that the application drawings and any supplementary instructions required by subsections (1) and (2), including special procedures required for non-typical floors, are made available to workers involved in any part of the assembly, flying, use, dismantling or reuse of each flyform panel.
Read the Occupational Health and Safety Regulation on BC Laws ↗

Made under Workers Compensation Act, RSBC 2019, c. 1.