Occupational Health and Safety Regulation, B.C. Reg. 296/97
Section 14.75
Before use
Cite as Occupational Health and Safety Regulation, B.C. Reg. 296/97, s. 14.75 · last amended September 1, 2027 · read from BC Laws on November 17, 2026
The text
(1) Before a tower crane is put in service, a qualified supervisor must verify that the tower crane has been erected, climbed or repositioned according to
(a) the manufacturer's specifications, or
(b) the specifications of a professional engineer, if the engineer has authorized the crane to be erected, climbed or repositioned otherwise.
(2) If a tower crane is not erected, climbed or repositioned according to the manufacturer's specifications, a professional engineer must certify before the crane is put in service that
(a) the variations from the manufacturer's specifications meet the requirements of the applicable design or safety standard,
(b) the load charts are adjusted as necessary, and
(c) the crane is safe for use.
(3) If a tower crane is erected, climbed or repositioned, a qualified person must adjust the overload prevention system as necessary according to
(a) the manufacturer's specifications, or
(b) the specifications of a professional engineer, if the engineer has authorized the crane to be erected, climbed or repositioned otherwise.
(4) If the climbing or repositioning of a tower crane affects any connections, bracing or shoring certified by a professional engineer under section 14.74 (3), before the tower crane is put into service, a professional engineer must certify that
(a) any parts of the tower crane affected by the climbing or repositioning have been properly installed, and
(b) the connections to and any bracing or shoring of the building or structure supporting the tower crane are in place.
(5) Before a tower crane is put in service following its erection, climbing or repositioning, a qualified supervisor must make available at the workplace at which the crane is installed a report
(a) verifying that
(i) the requirement in subsection (1) has been met,
(ii) copies of any certifications required under subsections (2) and (4) of this section and section 14.74 are available at the workplace, and
(iii) the overload prevention system of the crane has been adjusted as required by subsection (3) of this section,
(b) specifying the load limits set for the limit devices, as defined in section 14.81 (0.1), on the tower crane, and
(c) specifying the weight of each counterweight and any ballast installed on the tower crane.
Read the Occupational Health and Safety Regulation on BC Laws ↗
Made under Workers Compensation Act, RSBC 2019, c. 1.