Occupational Health and Safety Regulation, B.C. Reg. 296/97

Section 12.57

Limitations on use

Cite as Occupational Health and Safety Regulation, B.C. Reg. 296/97, s. 12.57 · last amended September 1, 2027 · read from BC Laws on November 17, 2026

The text

(1) A powder actuated tool fastener must not be driven into very hard or brittle materials, such as cast iron, glazed tile, hardened steel, glass block, natural rock, hollow tile, and most brick. (2) A powder actuated tool fastener may only be driven into easily penetrated or thin materials or materials of unknown resistance if the receiving material is backed by a material that will prevent the fastener from passing completely through. (3) A powder actuated tool fastener must not be driven into steel within 13 mm (1/2 in) of an edge, or within 5 cm (2 in) of a weld except for special applications permitted by the tool manufacturer. (4) Except for special applications recommended by the manufacturer, a powder actuated tool fastener may not be driven into masonry materials (a) within 7.5 cm (3 in) of an unsupported edge with a low velocity tool, or (b) within 15 cm (6 in) of an unsupported edge with a medium or high velocity tool. (5) A powder actuated tool fastener must not be driven (a) into concrete unless material thickness is at least 3 times the fastener shank penetration, (b) into any spalled area, or (c) through existing holes unless a specific guide means, as recommended and supplied by the tool manufacturer, is used to assure positive alignment.
Read the Occupational Health and Safety Regulation on BC Laws ↗

Made under Workers Compensation Act, RSBC 2019, c. 1.