Electrical Safety Regulation, B.C. Reg. 100/2004
Section 18
When permit is not required for electrical work
Cite as Electrical Safety Regulation, B.C. Reg. 100/2004, s. 18 · last amended March 4, 2025 · read from BC Laws on November 17, 2026
The text
(1) No permit is required if the only electrical work performed is testing.
(2) An individual may replace the following regulated products without a permit, up to a maximum rating of 150 volts to ground, with electrical equipment of a similar type or rating:
(a) receptacles;
(b) cord attachment plugs;
(c) snap switches;
(d) ballasts;
(e) dimmer switches;
(f) fan speed controllers;
(g) thermostats;
(h) overcurrent devices.
(3) An individual may replace, without a permit, a lamp of up to 347 volts to ground with a lamp of a similar type or rating.
(4) An individual may replace, without a permit, a fuse of up to 750 volts with a fuse of a similar type or rating.
(5) If a licensed electrical contractor or a manufacturer's technical representative performs repairs involving the components of existing installed and certified regulated electrical equipment, no permit is required if
(a) there are no modifications or additions to the electrical installation,
(b) neither the electrical rating nor the characteristics of the equipment is altered, and
(c) the replacement components are of a type which do not invalidate the original certification mark.
(6) If a licensed electrical contractor or a manufacturer's technical representative performs maintenance on, or a repair of, a class 2 security alarm system, or replaces parts of a class 2 security alarm system, no permit is required if the conditions set out in subsection (5) (b) and (c) are met.
(7) For the purposes of subsection (6), “class 2 security alarm system” means a security alarm system that is powered by a class 2 circuit.
Read the Electrical Safety Regulation on BC Laws ↗
Made under Safety Standards Act, SBC 2003, c. 39.