Chromium Electroplating, Chromium Anodizing and Reverse Etching Regulations, SOR/2009-162

Section 11

Cite as Chromium Electroplating, Chromium Anodizing and Reverse Etching Regulations, SOR/2009-162, s. 11 · current to July 24, 2025 · regulation last amended March 16, 2020

Statute Watch

Get an alert when a bill in Parliament would change this section, and every time it moves.

The text

(1) Every person that performed a release test under section 5 must, within 75 days after the last sample is taken for the test, submit to the Minister a report containing the following information respecting each point source and those tanks using the point source control method: (a) the date the sampling was performed, the time at which the sampling was started and the time at which it was completed; (b) the test results; (c) the location on a floor plan of the point source and of any tanks, control devices and fans that were connected to the point source at the time the sampling was performed; (d) the test method used; (e) in respect of tanks connected to the point source at the time of the sampling, the number of tanks in use and the number of tanks that were not in use, if any; (f) a description of the ventilation system for each tank in use and connected to the point source at the time the sampling was performed; (g) the respective diameters of the ducts linking each tank in use to a control device at the time the sampling was performed; (h) the electrical output setting for each tank’s rectifier at the time the sampling was performed; (i) if a stack was used at the time the sampling was performed, the dimensions of the stack, the diameter and location of each sampling port in relation to the point of release from the stack and, if an extension was required to conduct the three sampling runs of the test, the type of extension, its dimensions and the location on the extension of each sampling port; (j) the dimensions, type and the name of the manufacturer of each control device in use at the time the sampling was performed and the model and the name of the manufacturer of each control device fan in use at the time the sampling was performed and its rated capacity as established by its manufacturer; and (k) the concentration, in mg/dscm, of hexavalent chromium, if measured separately, or, in any other case, of total chromium, released during each of the three sampling runs required and the average concentration calculated for those runs. (2) Every person referred to in section 7 must submit to the Minister, no later than July 31 of every calendar year, a report setting out the surface tension recorded from January 1 to June 30 of the year in question, and must submit, no later than January 31 of the next calendar year, a report setting out the surface tension recorded from July 1 to December 31 of the preceding calendar year. (3) For the year in which this section comes into force, only one report must be submitted, setting out the surface tension recorded during the remainder of that year, no later than January 31 of the year following the year this section comes into force. (4) The reports required under this section must be in a form determined by the Minister.
Read the Chromium Electroplating, Chromium Anodizing and Reverse Etching Regulations on the Justice Laws Website ↗

Made under Canadian Environmental Protection Act, 1999, S.C. 1999, c. 33.

Bills in Parliament that would change this section 0

No bill we hold would amend or repeal this section.