MINES AND MINING PLANTS, R.R.O. 1990, Reg. 854
Section 36
Cite as MINES AND MINING PLANTS, R.R.O. 1990, Reg. 854, s. 36 · current to November 11, 2026 · consolidated from July 1, 2025 · read from e-Laws on November 16, 2026
The text
(1) Where a blow torch or welding, cutting or other hot work equipment is used underground, or in a headframe, shaft house or other surface building in which a fire may endanger the mine entrance or the underground workings, a procedure for the safe use of hot work equipment shall be prepared in writing and signed by the supervisor in charge of the mine. R.R.O. 1990, Reg. 854, s. 36 (1).
(2) Only a worker who is a competent person or is under the direction of a competent person shall use hot work equipment. R.R.O. 1990, Reg. 854, s. 36 (2).
(3) In addition to the hot work procedure required by subsection (1), written instructions shall be issued to the worker by a supervisor before the hot work equipment is used respecting,
(a) the type of work;
(b) the location of the work;
(c) when the work is to be done; and
(d) any special measures and procedures to be taken before, during and after the work. R.R.O. 1990, Reg. 854, s. 36 (3).
(4) Where hot work equipment is used in a shaft, timbered area or fire hazard area,
(a) the area adjacent to the particular workplace shall be wet down,
(i) before the work is begun, and
(ii) when the work is stopped and the worker using the hot work equipment intends to leave;
(b) the area adjacent to the particular workplace shall be examined for potential fire hazards,
(i) before the work is begun, and
(ii) when the work is stopped and the worker intends to leave the area, and
(iii) on at least one other occasion approximately two hours after the work is stopped;
(c) fire-fighting equipment suitable for extinguishing any potential fire shall be available; and
(d) workers shall be protected from fumes, vapours or gases by,
(i) ventilation, or
(ii) the wearing of respirators. R.R.O. 1990, Reg. 854, s. 36 (4).
(5) Subsection (1) does not apply to hot work being performed in a repair station or garage protected by a fire suppression system. R.R.O. 1990, Reg. 854, s. 36 (5).
(6) Clause (4) (a) does not apply where the wetting down will create a hazard because of freezing or the presence of electrical equipment. R.R.O. 1990, Reg. 854, s. 36 (6).
Read the MINES AND MINING PLANTS on e-Laws ↗
Made under Occupational Health and Safety Act, R.S.O. 1990, c. O.1.