MINES AND MINING PLANTS, R.R.O. 1990, Reg. 854
Section 236
Cite as MINES AND MINING PLANTS, R.R.O. 1990, Reg. 854, s. 236 · current to November 11, 2026 · consolidated from July 1, 2025 · read from e-Laws on November 16, 2026
The text
(1) A signal for hoist movement shall be given only,
(a) by an authorized worker; and
(b) when the shaft conveyance or counterweight is at the same location as the worker signalling, except during,
(i) shaft sinking and preliminary shaft development, or
(ii) maintenance work in a shaft or on a mine hoisting plant. R.R.O. 1990, Reg. 854, s. 236 (1); O. Reg. 265/15, s. 13.
(2) No hoist shall be moved on manual control unless,
(a) the signal prescribed under this section is given;
(b) the signal is returned by the hoist operator; and
(c) at least four seconds have elapsed after the executive signal has been given. R.R.O. 1990, Reg. 854, s. 236 (2).
(3) Signals shall be given in the following sequence:
1. Cautionary.
2. Destination.
3. Executive. R.R.O. 1990, Reg. 854, s. 236 (3).
(4) The following basic code of signals to a hoist operator shall be used:
Table
Column 1 Instruction to Hoist Operator | Column 2 Signal Code
Stop immediately | 1 signal
Where the shaft conveyance is stationary, hoist | 1 signal
Lower | 2 signals
Persons entering or leaving a shaft conveyance | 3 signals
Caution — blasting to take place | 4 signals
Release of shaft conveyance | 5 signals
Danger | 9 signals
Chairing | 1 signal followed by 2 signals
Hoist slowly | 3 signals, followed by 3 signals, followed by 1 signal
Lower slowly | 3 signals, followed by 3 signals, followed by 2 signals
(5) In addition to the basic code of signals prescribed by subsection (4), the tender of a shaft conveyance shall comply with the Code of Standard Signals issued by the Ministry. R.R.O. 1990, Reg. 854, s. 236 (5).
(6) Where it is necessary for the operation of a shaft conveyance, the supervisor in charge of an underground mine may establish signals in addition to those prescribed by subsections (4) and (5). R.R.O. 1990, Reg. 854, s. 236 (6).
(7) The basic code of signals and destination signals shall be posted in every hoistroom, working level and landing deck. R.R.O. 1990, Reg. 854, s. 236 (7).
Read the MINES AND MINING PLANTS on e-Laws ↗
Made under Occupational Health and Safety Act, R.S.O. 1990, c. O.1.