MINES AND MINING PLANTS, R.R.O. 1990, Reg. 854

Section 211

Cite as MINES AND MINING PLANTS, R.R.O. 1990, Reg. 854, s. 211 · current to November 11, 2026 · consolidated from July 1, 2025 · read from e-Laws on November 16, 2026

The text

(1) This section applies if a shaft conveyance is being used to transport persons. O. Reg. 31/04, s. 12. (2) The hoist shall be equipped with control devices that prevent the shaft conveyance from being taken, (a) to the dump position, unless a procedure is established and followed that ensures persons on the shaft conveyance remain securely in place if the conveyance is taken to the dump position; or (b) below a loading pocket, unless the controls for loading the shaft conveyance from that pocket have been made inoperative or the persons are being transported in a separate compartment of the shaft. O. Reg. 31/04, s. 12. (3) If a shaft conveyance that is being used to transport persons is not a cage or a combination skip and cage designed to normally transport persons, the hoist shall not be permitted to travel at a speed that is more than the lesser of, (a) one-half the normal speed of the hoist; or (b) five metres per second. O. Reg. 31/04, s. 12. (4) The control devices of the hoist shall be designed and installed to be fail safe. O. Reg. 31/04, s. 12. (5) An audible or visible signal that the control devices for the hoist are set in operation shall be given to persons entering the shaft conveyance. O. Reg. 31/04, s. 12.
Read the MINES AND MINING PLANTS on e-Laws ↗

Made under Occupational Health and Safety Act, R.S.O. 1990, c. O.1.