Integrated Accessibility Standards, O. Reg. 191/11

Section 80.25

Exterior paths of travel, stairs

Cite as Integrated Accessibility Standards, O. Reg. 191/11, s. 80.25 · current to November 11, 2026 · consolidated from March 30, 2026 · read from e-Laws on November 16, 2026

The text

Where stairs connect to exterior paths of travel, the stairs must meet the following requirements: 1. The surface of the treads must have a finish that is slip resistant. 2. Stairs must have uniform risers and runs in any one flight. 3. The rise between successive treads must be between 125 mm and 180 mm. 4. The run between successive steps must be between 280 mm and 355 mm. 5. Stairs must have closed risers. 6. The maximum nosing projection on a tread must be no more than 38 mm, with no abrupt undersides. 7. Stairs must have high tonal contrast markings that extend the full tread width of the leading edge of each step. 8. Stairs must be equipped with tactile walking surface indicators that are built in or applied to the walking surface, and the tactile walking surface indicators must, i. have raised tactile profiles, ii. have a high tonal contrast with the adjacent surface, iii. be located at the top of all flights of stairs, and iv. extend the full tread width to a minimum depth of 610 mm commencing one tread depth from the edge of the stair. 9. Handrails must be included on both sides of stairs and must satisfy the requirements set out in paragraph 7 of subsection 80.24 (1). 10. A guard must be provided that is not less than 920 mm, measured vertically to the top of the guard from a line drawn through the outside edges of the stair nosings and 1,070 mm around the landings and is required on each side of a stairway where the difference in elevation between ground level and the top of the stair is more than 600 mm but, where there is a wall, a guard is not required on that side. 11. Where stairs are more than 2,200 mm in width, i. one or more intermediate handrails that are continuous between landings must be provided and located so there is no more than 1,650 mm between handrails, and ii. the handrails must satisfy the requirements set out in paragraph 7 of subsection 80.24 (1). O. Reg. 413/12, s. 6.
Read the Integrated Accessibility Standards on e-Laws ↗

Made under Accessibility for Ontarians with Disabilities Act, 2005, S.O. 2005, c. 11.