Designated Substance — asbestos on construction projects and in buildings and repair operations, O. Reg. 278/05
Section 15
Measures and procedures, Type 2 and Type 3 operations
Cite as Designated Substance — asbestos on construction projects and in buildings and repair operations, O. Reg. 278/05, s. 15 · current to November 11, 2026 · consolidated from July 1, 2026 · read from e-Laws on November 16, 2026
The text
The following measures and procedures apply to Type 2 operations and to Type 3 operations:
1. The work area shall be identified by clearly visible signs warning of an asbestos dust hazard.
2. Signs required by paragraph 1 shall be posted in sufficient numbers to warn of the hazard and shall state in large clearly visible letters that,
i. there is an asbestos dust hazard, and
ii. access to the work area is restricted to persons wearing protective clothing and equipment.
3. A wetting agent shall be added to water that is to be used to control the spread of dust and fibres.
4. Eating, drinking, chewing or smoking shall not be permitted in the work area.
5. Containers for dust and waste shall be,
i. dust tight,
ii. suitable for the type of waste,
iii. impervious to asbestos,
iv. identified as asbestos waste,
v. cleaned with a damp cloth or a vacuum equipped with a HEPA filter immediately before being removed from the work area, and
vi. removed from the workplace frequently and at regular intervals.
6. Frequently and at regular intervals during the doing of the work and immediately on completion of the work,
i. dust and waste shall be cleaned up and removed using a vacuum equipped with a HEPA filter, or by damp mopping or wet sweeping, and placed in a container as described in paragraph 5, and
ii. drop sheets shall be wetted and placed in a container as described in paragraph 5, as soon as practicable after subparagraph i has been complied with.
7. Drop sheets shall not be reused.
8. After the work is completed, polyethylene sheeting and similar materials used for barriers and enclosures shall not be reused, but shall be wetted and placed in a container as described in paragraph 5 as soon as practicable after paragraph 6 has been complied with.
9. After the work is completed, barriers and portable enclosures that will be reused shall be cleaned, by using a vacuum equipped with a HEPA filter or by damp wiping, as soon as practicable after paragraphs 6 and 8 have been complied with.
10. Barriers and portable enclosures shall not be reused unless they are rigid and can be cleaned thoroughly.
11. The employer shall provide every worker who will enter the work area with a NIOSH or CSA approved respirator in accordance with Table 2 and the worker shall wear and use the respirator.
12. Protective clothing shall be provided by the employer and worn by every worker who enters the work area, and the protective clothing,
i. shall be made of a material that does not readily retain nor permit penetration of asbestos fibres,
ii. shall consist of head covering and full body covering that fits snugly at the ankles, wrists and neck, in order to prevent asbestos fibres from reaching the garments and skin under the protective clothing,
iii. shall include suitable footwear, and
iv. shall be repaired or replaced if torn.
13. Compressed air shall not be used to clean up and remove dust from any surface.
14. Only persons wearing protective clothing and equipment shall enter a work area where there is an asbestos dust hazard. O. Reg. 278/05, s. 15; O. Reg. 115/26, s. 3.
Read the Designated Substance — asbestos on construction projects and in buildings and repair operations on e-Laws ↗
Made under Occupational Health and Safety Act, R.S.O. 1990, c. O.1.