Boiler and Pressure Vessel Code, N.B. Reg. 84-174

Section 503

WELDER’S QUALIFICATION TESTS

Cite as Boiler and Pressure Vessel Code, N.B. Reg. 84-174, s. 503 · current to August 1, 2026 · read from New Brunswick Acts and Regulations on November 16, 2026

The text

(1) Every application for a welder’s qualification test is subject to the approval of the Chief Inspector or a welder test organization approved by the Chief Inspector, as the case may be. (1.1) The Chief Inspector or a welder test organization approved by the Chief Inspector, as the case may be, shall, in the discretion of the Chief Inspector or the welder test organization, determine whether or not the applicant has sufficient experience and knowledge to warrant a welder’s qualification test. (2) Welder’s qualification tests shall be as required by the Chief Inspector and shall as far as practicable be in accordance with the welding test requirements of the ASME Boiler and Pressure Vessel Code and the applicable ANSI standards prescribed in the Standards Regulation - Boiler and Pressure Vessel Act. (3) Repealed: 2014-96 (4) Repealed: 2014-96 (5) A welder may be retested at any time at the request of the Chief Inspector. (6) A welder shall be tested in all methods and types of welding and for every position in which he will be required to weld, but if a welder successfully passes a butt weld test, the Chief Inspector or a welder test organization approved by the Chief Inspector, as the case may be, may, in the discretion of the Chief Inspector or the welder test organization, waive the requirement for a fillet weld test for the same position. (7) A welder shall qualify for all positions before an authorization will be issued to him for welding pressure piping in the fixed position.
Read the Boiler and Pressure Vessel Code on the Province's website ↗

Made under Boiler and Pressure Vessel Act, 2011, c.122.