Boiler and Pressure Vessel Code, N.B. Reg. 84-174
Section 502
RESPONSIBILITY OF MANUFACTURERS AND WELDERS
Cite as Boiler and Pressure Vessel Code, N.B. Reg. 84-174, s. 502 · current to August 1, 2026 · read from New Brunswick Acts and Regulations on November 16, 2026
The text
Every manufacturer, contractor, welding shop operator or any other person who welds or employs any person to do any welding upon any boiler, pressure vessel or pressure piping system is responsible for the quality of the welding done upon such boiler, pressure vessel or pressure piping system and before any such welding commences shall:
(a) conduct approved welding procedure tests in accordance with the requirements of the ASME Boiler and Pressure Vessel Code and the applicable ANSI standards prescribed in the Standards Regulation - Boiler and Pressure Vessel Act to ensure that the procedure to be used will produce sound welds able to meet such requirements and shall submit proof of such procedure tests to the Department for recording or registration;
(b) arrange for a welder’s qualification test administered by
(i) the Chief Inspector, or
(ii) a welder test organization approved by the Chief Inspector;
(c) ascertain, where there is new construction, that the design of the pressure vessel has been registered with the Chief Inspector and allotted a registration number and, where there is repair work, that approval has been granted by the Chief Inspector; and
(d) supply all materials and equipment necessary to conduct procedure and performance tests.
Read the Boiler and Pressure Vessel Code on the Province's website ↗
Made under Boiler and Pressure Vessel Act, 2011, c.122.