Antisapstain Chemical Waste Control Regulation, B.C. Reg. 300/90

Section 7

Design of antisapstain chemical dip tank systems

Cite as Antisapstain Chemical Waste Control Regulation, B.C. Reg. 300/90, s. 7 · last amended July 8, 2004 · read from BC Laws on November 17, 2026

The text

(1) An antisapstain chemical dip tank shall (a) be impervious, (b) if it is an above ground tank, be located in an impervious containment area which has (i) a sloped floor, and (ii) a curb that is of sufficient height to enable the containment area to hold at least 120% of the largest chemical dip tank volume, and that prevents entry of surface runoff, (c) if it is not an above ground tank, be a double wall containment tank constructed with (i) both walls impervious, and (ii) a means for determining if there is leakage of the chemicals into the area between the walls, (d) have an associated impervious primary drip area that provides 30 minutes minimum dripping time for treated wood immediately following the treatment and that prevents entry to the dip tank of surface runoff and precipitation, (e) have a system for recycling all drippings from the containment area referred to in paragraphs (b) and (c) and from the impervious drip area referred to in paragraph (d) back to the dip tank, and (f) be constructed so as to prevent a motorized vehicle of a type that can reasonably be expected to operate near the dip tank from driving in or through the dip tank. (2) The containment area referred to in subsection (1) (b), the tank referred to in subsection (1) (c) and the primary drip area referred to in subsection (1) (d) shall be provided with a fixed roof and with guard rails or equivalent to provide vehicle impact protection. (3) Repealed. [B.C. Reg. 321/2004, s. 3 (h).]
Read the Antisapstain Chemical Waste Control Regulation on BC Laws ↗

Made under Environmental Management Act, SBC 2003, c. 53.