Occupational Health and Safety Regulation, B.C. Reg. 296/97
Section 5.13
Laboratory label
Cite as Occupational Health and Safety Regulation, B.C. Reg. 296/97, s. 5.13 · last amended September 1, 2027 · read from BC Laws on November 17, 2026
The text
(1) If a laboratory sample of a hazardous product is the subject of a labelling exemption under the Hazardous Products Regulations, a label provided by the supplier and affixed to, printed on or attached to the container of the product received at the workplace that discloses the following information in place of the information required under the Hazardous Products Regulations complies with the requirements of section 5.8 of this Part with respect to a supplier label:
(a) the chemical name or generic chemical name of any material or substance in the hazardous product that, individually, is classified, pursuant to the Hazardous Products Act and the Hazardous Products Regulations, in any category or subcategory of a health hazard class and is present above the relevant concentration limit, or is present at a concentration that results in the mixture being classified in a category or subcategory of any health hazard class, if known by the supplier;
(b) the statement "Hazardous Laboratory Sample. For hazard information or in an emergency, call / Échantillon pour laboratoire de produit dangereux. Pour obtenir des renseignements sur les dangers ou en cas d'urgence, composez" followed by an emergency telephone number for the purpose of obtaining information that must be provided on the SDS of the hazardous product.
(2) If a hazardous product is in a container other than the container in which it was received from a supplier, or is produced in the workplace, the employer is exempt from the requirement set out in section 5.10 if the hazardous product
(a) is a laboratory sample,
(b) is intended by the employer solely for use, analysis, testing or evaluation in a laboratory, and
(c) is clearly identified through a combination of
(i) a mode of identification visible to workers at the workplace, and
(ii) worker education and training required by this Part.
(3) The employer must ensure that the mode of identification and worker education and training referred to in subsection (2) (c) enable the worker to readily identify and obtain either the information required on an SDS, if one has been produced, or a label or document disclosing the information referred to in subsection (1) (a) and (b) with respect to the hazardous product or the laboratory sample.
Read the Occupational Health and Safety Regulation on BC Laws ↗
Made under Workers Compensation Act, RSBC 2019, c. 1.