Occupational Health and Safety Regulation, B.C. Reg. 296/97

Section 4.58

Specifications for guards and guardrails

Cite as Occupational Health and Safety Regulation, B.C. Reg. 296/97, s. 4.58 · last amended September 1, 2027 · read from BC Laws on November 17, 2026

The text

(1) Guards in a building must be appropriate for the use and occupancy of the area. (2) Guards in areas not part of a building must meet the applicable criteria of subsections (3) to (5), or other standard acceptable to the Board. (3) Unless otherwise permitted by subsections (4) and (4.1), guardrails must be installed to withstand a load applied horizontally and normal to the span of the rail, of 550 N (125 lb.) applied at any point along the rail, and a vertical, downward load of 1.5 kN per m (100 lb. per ft.) along the top rail, but the horizontal and vertical loads need not be considered to act simultaneously. (4) Guardrails temporarily installed during the construction, demolition, maintenance or renovation of a work area must be able to withstand a load of 550 N (125 lb.) applied perpendicular to the span in a horizontal or vertically downward direction at any point on the top rail, or be built to the criteria of subsection (5). (4.1) If part or all of the top rail or a midrail of a guardrail that is temporarily installed during the construction, demolition, maintenance or renovation of a work area is made of fibre rope, wire rope, chain or other non-rigid material, that part of the guardrail must meet the requirements of WorkSafeBC Standard — Guardrails using rope or other non-rigid material, as set out in Schedule 4-A to this Part. (5) Unless designed by a professional engineer, temporary wooden guardrails on floors and platforms must meet the following criteria: (a) posts must be spaced not more than 2.4 m (8 ft.) apart, except a scaffold may have posts spaced not more than 3 m (10 ft.) apart; (b) wooden top rails must be at least 38 mm x 89 mm (2 in. x 4 in. nominal) lumber for a span of up to 2.4 m between supports, and at least 38 mm x 140 mm (2 in. x 6 in. nominal) lumber for a span of 2.4 m to 3 m between supports; (c) wooden midrails must be 19 mm x 140 mm (1 in. x 6 in. nominal) or 38 mm x 89 mm (2 in. x 4 in. nominal) lumber; (d) wooden rails must be secured to the tops or inner sides of their vertical supports; (e) wooden guardrail posts must be at least 38 mm x 89 mm (2 in. x 4 in. nominal) lumber, and must be installed with the narrow dimension facing the open edge; (f) plastic or wire mesh fencing of adequate strength may be used in place of the midrail, but posts and top rails must comply with the requirements of this section and such fencing must be secured in place.
Read the Occupational Health and Safety Regulation on BC Laws ↗

Made under Workers Compensation Act, RSBC 2019, c. 1.