Occupational Health and Safety Regulation, B.C. Reg. 296/97
Section 27.44
Wood products storage
Cite as Occupational Health and Safety Regulation, B.C. Reg. 296/97, s. 27.44 · last amended September 1, 2027 · read from BC Laws on November 17, 2026
The text
(1) A pile of lumber, veneer, plywood or similar wood product must be erected plumb and level, and be maintained in a stable condition.
(2) Spacing blocks which permit stable piling and unobstructed access for the forks of lift trucks must be placed beneath each pile and between loads.
(3) Veneer loads must be supported by at least 3 spacing blocks of sufficient size to permit stable piling and unobstructed access for the forks of lift trucks, and individual load height must not exceed 1 m (3.3 ft).
(4) Loads of lumber built up for storage or transportation must be stabilized
(a) using stripping material which, where feasible, does not protrude beyond the side of the load or package, or
(b) by other effective means.
(5) If wood products are piled on a foundation that is firm and level
(a) loads of lumber may be piled up to approximately 4.5 m (15 ft) high,
(b) unitized loads of lumber or loads of lumber 15 cm (6 in) or more in width may be piled up to approximately 6 m (20 ft) high, except for the outer pile which must not exceed 4.5 m (15 ft),
(c) if 3 or more loads of any size lumber are cross-tied at each successive level, the loads may be piled up to approximately 11 m (35 ft) high,
(d) veneer piled in the vicinity of passageways or work areas must be adequately supported to prevent falling,
(e) veneer storage piles must not exceed 4.5 m (15 ft) high, and
(f) loads of plywood and similar wood products may be piled up to approximately 6 m (20 ft) high except for the outer stack which must not exceed 4.5 m (15 ft).
Read the Occupational Health and Safety Regulation on BC Laws ↗
Made under Workers Compensation Act, RSBC 2019, c. 1.