Occupational Health and Safety Regulation, B.C. Reg. 296/97

Section 26.68.2

Securing log loads — entirely off-highway transportation routes

Cite as Occupational Health and Safety Regulation, B.C. Reg. 296/97, s. 26.68.2 · last amended September 1, 2027 · read from BC Laws on November 17, 2026

The text

(1) This section applies in relation to the transportation of a log load if no part of the transportation route, other than a crossing, is a highway. (2) A log load must be secured on a log transporter (a) by installing, on each log stack and on any logs that are not part of a log stack, the following number of wrappers or tiedowns that conform to subsection (3): (i) if the longest log that is to be secured by the wrappers or tiedowns is no more than 10.7 m (35 ft) long, at least 2 wrappers or tiedowns, each of which has a working load limit of at least 8.9 kN (2 000 lbf); (ii) if the longest log that is to be secured by the wrappers or tiedowns is more than 10.7 m (35 ft) long, at least 3 wrappers or tiedowns, each of which has a working load limit of at least 13.3 kN (3 000 lbf), or (b) without the use of wrappers or tiedowns by loading the logs (i) lengthwise with the horizontal centrelines of all of the logs below the top of the stakes on the log transporter, and (ii) in accordance with the requirements set out in a current risk assessment that conforms to subsection (4) for the log hauling operation. (3) A wrapper or tiedown installed for the purposes of subsection (2) (a) must (a) have a safety factor of at least the following: (i) if wire rope, 4; (ii) if polyester rope, 7; (iii) if any other synthetic rope, 12; (iv) if synthetic webbing, 3; (v) if chain, 4, and (b) if chain, have a grade of at least 70. (4) For the purposes of subsection (2) (b), a risk assessment for a log hauling operation must (a) be in writing, (b) be prepared by a qualified person, based on the circumstances of the log hauling operation, including, without limitation, (i) the speeds of the log transporters used in the operation, (ii) the type, design and condition of the surfaces that the log transporters will travel on, including their grades, (iii) the weather, and (iv) the log characteristics, (c) specify requirements for the loading, transportation and unloading of logs, and (d) set out the opinion of the qualified person that no logs, log chunks or debris will fall off a log transporter during loading, transportation or unloading of logs if the specified requirements are met. (5) A log load that is secured under subsection (2) (b) in reliance on a current risk assessment must be transported and unloaded in accordance with the requirements set out in that assessment.
Read the Occupational Health and Safety Regulation on BC Laws ↗

Made under Workers Compensation Act, RSBC 2019, c. 1.