Occupational Health and Safety Regulation, B.C. Reg. 296/97
Section 23.21
Rigging up and tearing out
Cite as Occupational Health and Safety Regulation, B.C. Reg. 296/97, s. 23.21 · last amended September 1, 2027 · read from BC Laws on November 17, 2026
The text
(1) The driver of a vehicle used for rigging up or tearing out equipment must not move the vehicle until signalled to move by a qualified signaller.
(2) The signaller must ensure that workers are clear of the path of the vehicle, load and load line.
(3) To prevent materials or equipment from rolling or sliding off a truck or trailer during unloading operations, load tie down devices must not be removed until the lifting slings and hoist line have been attached to the equipment or material that may slide or roll off, and slack in the hoist line and rigging has been taken up.
(4) A worker must not remain or ride on a load or part of a load being raised, lowered or moved.
(5) The movement of a load being raised or lowered must be controlled by
(a) a tag line long enough to ensure that the worker controlling it cannot be struck by the load, or
(b) where a helicopter is being used, by effective work procedures.
(6) A worker must not work, stand or pass
(a) under a suspended load,
(b) between the winch mechanisms and a load being winched, or
(c) in areas where the worker may be injured due to winch line or mechanism failure.
(7) Repealed. [B.C. Reg. 312/2003, App. B, s. 52.]
(8) Winch mechanisms, lines, slings, hooks and fittings must be inspected thoroughly by the equipment operator
(a) before commencing work, and
(b) at such intervals as the nature of the work may require.
Read the Occupational Health and Safety Regulation on BC Laws ↗
Made under Workers Compensation Act, RSBC 2019, c. 1.