Occupational Health and Safety Regulation, B.C. Reg. 296/97
Section 20.81
Sloping and shoring requirements
Cite as Occupational Health and Safety Regulation, B.C. Reg. 296/97, s. 20.81 · last amended September 1, 2027 · read from BC Laws on November 17, 2026
The text
(1) Subject to section 20.78, before a worker enters any excavation over 1.2 m (4 ft.) in depth or, while in the excavation, approaches closer to the side or bank than a distance equal to the depth of the excavation, the employer must ensure that the sides of the excavation are
(a) sloped as specified in writing by a qualified registered professional,
(b) sloped at angles, dependent on soil conditions, which will ensure stable faces, but in no case may the slope or combination of vertical cut and slope exceed that shown in Figure 20-1,
(c) benched as shown in Figure 20-2,
(d) supported as specified in writing by a professional engineer,
(e) supported in accordance with the minimum requirements of section 20.85, or
(f) supported by manufactured or prefabricated trench boxes or shoring cages, or other effective means.
(2) If the end of a trench over 1.2 m (4 ft.) in depth is not adequately sloped, end shoring must be installed unless
(a) a worker in the trench is not required to approach closer to the end of the trench than a distance equal to the depth of the trench at that end,
(b) where, for the prevailing soil conditions at the end of the trench, the permissible spacing of uprights equals or exceeds the width of the trench, or
(c) otherwise authorized in writing by a professional engineer or professional geoscientist.
(3) If end shoring is required, the walers for the end shoring must be installed to bear against the walers that extend along the sides of the trench, or in a manner that will provide equivalent structural restraint.
(4) End shoring must be designed by a professional engineer if the end shoring waler length exceeds 1.8 m (6 ft.).
(5) Shoring must extend from at least 30 cm (1 ft.) above ground level to as close to the bottom of the trench as the material being installed will allow, but in no case more than 60 cm (2 ft.) from the bottom.
(6) Shoring need not extend above ground level where traffic crossing plates need to be used, provided that other measures are taken to prevent excavated or other material from entering the excavation.
Read the Occupational Health and Safety Regulation on BC Laws ↗
Made under Workers Compensation Act, RSBC 2019, c. 1.