Occupational Health and Safety Regulation, B.C. Reg. 296/97
Section 19.36
General requirements
Cite as Occupational Health and Safety Regulation, B.C. Reg. 296/97, s. 19.36 · last amended September 1, 2027 · read from BC Laws on November 17, 2026
The text
(1) A control system must be designed, installed, operated and maintained in accordance with a standard acceptable to the Board.
(2) Only qualified and authorized persons may design, install, operate and maintain a control system.
(3) When designing a control system, the types of potential system failure and the effects of failures on the control system and the controlled equipment must be analysed.
(4) Where practicable and required to minimize risk to workers, a control system must be designed so that
(a) the controlled equipment cannot be inadvertently activated,
(b) an effective basic diagnostic capability is incorporated,
(c) hardwired emergency stop devices are provided at operator stations, and
(d) operator controls other than emergency stop devices can be activated at only one station at a time.
(5) A control system must be used to prevent automatic startup after a power interruption or low voltage occurrence, if automatic startup in such circumstances is likely to create a hazard to workers.
(6) A control system must, where practicable, be designed so that the controlled equipment does not create a hazard to workers if the system fails or is shut down.
(7) Equipment operated by a new or altered control system must not be used until the control system has been thoroughly checked and tested to verify that it will function in the intended manner.
(8) The employer must ensure there is up-to-date documentation which is readily available to affected workers describing the design, installation, operation and maintenance of a control system.
(9) Control system hardware must be protected from circumstances that could adversely affect the performance of the system including mechanical damage, vibration, extreme temperatures or humidity levels, high electromagnetic field levels, and power disturbances.
(10) Written safe work procedures must be developed for the use of equipment operated by a control system, including lockout procedures as required by this Regulation.
Read the Occupational Health and Safety Regulation on BC Laws ↗
Made under Workers Compensation Act, RSBC 2019, c. 1.