Occupational Health and Safety Regulation, B.C. Reg. 296/97
Section 19.10
Disconnection and lockout
Cite as Occupational Health and Safety Regulation, B.C. Reg. 296/97, s. 19.10 · last amended September 1, 2027 · read from BC Laws on November 17, 2026
The text
(1) Low voltage electrical equipment must be completely disconnected and locked out as required by this Regulation before starting work on it.
(2) Except as specified in subsection (3), if it is not practicable to completely disconnect low voltage electrical equipment, work must be performed by qualified and authorized workers and in accordance with written safe work procedures which
(a) require the use of personal protective equipment and voltage-rated tools, appropriate to the hazards and risks associated with the voltage at which the electrical equipment is operating,
(b) provide that, if practicable, uncontrolled liquid is not permitted close to any worker working on the equipment, and
(c) if applicable, control the use of metal ladders, wooden ladders with wire reinforced side rails, metal scaffolds or metal work platforms.
(3) Work must not be done on energized parts of electrical equipment associated with lighting circuits operating at more than 250 volts-to-ground without the prior written permission of the Board.
Read the Occupational Health and Safety Regulation on BC Laws ↗
Made under Workers Compensation Act, RSBC 2019, c. 1.