Occupational Health and Safety Regulation, B.C. Reg. 296/97

Section 16.16

Tire servicing

Cite as Occupational Health and Safety Regulation, B.C. Reg. 296/97, s. 16.16 · last amended September 1, 2027 · read from BC Laws on November 17, 2026

The text

(1) An employer must establish and implement safe work procedures for servicing tires, rims and wheels of mobile equipment, including safe procedures for (a) inspecting tire, rim and wheel components, (b) mounting a tire to the rim and wheel, (c) inflating a tire, (d) installing and removing tire assemblies, and (e) demounting tires from the rim and wheel assemblies. (2) Deflation of a tire must be done in an area where ignition sources are removed or controlled. (3) Each tire, rim and wheel part must be cleaned and inspected for damage before mounting, and cracked, broken, bent or otherwise damaged parts replaced. (4) A person inflating a tire must stay out of the potential explosion trajectory, if it is practical to do so, and actively monitor the tire's inflation pressure. (5) If a bead expander is used to seat the beads of a tire, it must be removed before the tire is inflated to more than 0.35 bar (5 psi). (6) When a tire mounted on a single piece rim or wheel with a diameter more than 49.5 cm (19.5 in) is being inflated to more than 5.52 bar (80 psi), after the beads are seated, the combination of the tire with the rim or wheel must be (a) mounted on the mobile equipment, (b) placed in a cage or other effective restraining device, or (c) restrained by an effective barrier, other than a chain. (7) After the components of a multipiece rim or wheel are set in place, a tire must not be inflated to operating pressure until the rim or wheel is mounted onto the mobile equipment or has been secured in a cage or engineered containment device. (8) Assembled rim or wheel parts must not be welded or heated, except in a limited manner to facilitate removal of a wheel from a hub after the tire has been deflated by removing the valve core. (9) Before loosening any wheel nuts or rim clamps, a tire mounted on a multipiece rim or wheel, (a) if larger than 900R20 (900-20), must be deflated to less than 1.38 bar (20 psi), and (b) if equal to or smaller than 900R20 (900-20), must be completely deflated to 0 bar (0 psi). (10) A multipiece tire and rim or wheel assembly that has been used at less than 80% of the recommended inflation pressure for that application must be deflated, disassembled and inspected before reinflation.
Read the Occupational Health and Safety Regulation on BC Laws ↗

Made under Workers Compensation Act, RSBC 2019, c. 1.