Occupational Health and Safety Regulation, B.C. Reg. 296/97
Section 15.54
Synthetic web sling rejection criteria
Cite as Occupational Health and Safety Regulation, B.C. Reg. 296/97, s. 15.54 · last amended September 1, 2027 · read from BC Laws on November 17, 2026
The text
A synthetic fibre web sling must be removed from service when any of the following circumstances occurs:
(a) the length of an edge cut exceeds the web thickness;
(b) the penetration of abrasion exceeds 15% of the webbing thickness taken as a proportion of all plies;
(c) abrasion occurs on both sides of the webbing and the sum of the abrasion on both sides exceeds 15% of the webbing thickness taken as a proportion of all plies;
(d) warp thread damage up to 50% of the sling thickness extends to within 1/4 of the sling width of the edge or exceeds 1/4 the width of the sling;
(e) warp thread damage to the full depth of the sling thickness extends to within 1/4 of the sling width of the edge or the width of damage exceeds 1/8 the width of the sling;
(f) weft thread damage allows warp thread separation exceeding 1/4 the width of the sling and extends in length more than twice the sling width;
(g) any part of the sling is melted or charred, or is damaged by acid or caustic;
(h) stitches in load bearing splices are broken or worn;
(i) end fittings are excessively pitted or corroded, cracked, distorted or broken;
(j) a combination of the above types of damage of approximately equal total effect are present.
Read the Occupational Health and Safety Regulation on BC Laws ↗
Made under Workers Compensation Act, RSBC 2019, c. 1.