Occupational Health and Safety Regulation, B.C. Reg. 296/97
Section 14.81
Limit devices
Cite as Occupational Health and Safety Regulation, B.C. Reg. 296/97, s. 14.81 · last amended September 1, 2027 · read from BC Laws on November 17, 2026
The text
(0.1) In this section:
“limit device” means a device on a tower crane that is designed to control the loads or motions of the crane, and includes the switches and devices described in subsections (1) and (5);
“warning device” means a device, such as a visual signal, audio signal or gauge, attached to a limit device that indicates when the limit device malfunctions.
(1) A tower crane must have automatic travel limit switches and automatic overload prevention devices that prevent overloading at any trolley position, the load block from travelling beyond the highest allowable position specified by the manufacturer and the trolley from travelling beyond the allowable limit specified by the manufacturer.
(2) Subject to subsection (4), limit devices on a tower crane must be tested before the crane is first used on each work shift
(a) in accordance with the manufacturer's testing procedures, or
(b) if the manufacturer's testing procedures are not available, in accordance with testing procedures approved by a professional engineer.
(3) Any malfunction of a limit device, warning device or safety device on a tower crane that is discovered after testing or at any other time must be remedied before the crane is used.
(4) If it is not practicable, due to the configuration of the workplace, to position sufficient test weights to test the maximum load limit switch before the crane is first used on each work shift, the maximum load limit switch must
(a) be set to activate at a load of less than 80% of the maximum rated capacity for the crane and tested using test blocks, and
(b) be reset to the maximum load limit for the crane and tested using test blocks before making any lift that is greater than the load limit setting established under paragraph (a).
(5) A tower crane with a luffing boom must have an automatic limit device that prevents the boom being raised beyond the maximum permitted boom angle.
(6) In subsection (5), “luffing boom” means a boom that is raised and lowered about a pivot point to change the load radius.
Read the Occupational Health and Safety Regulation on BC Laws ↗
Made under Workers Compensation Act, RSBC 2019, c. 1.