Occupational Health and Safety Regulation, B.C. Reg. 296/97

Section 13.30

Lift truck mounted work platforms

Cite as Occupational Health and Safety Regulation, B.C. Reg. 296/97, s. 13.30 · last amended September 1, 2027 · read from BC Laws on November 17, 2026

The text

(1) In this section, “work platform” means a movable work platform that is supported by a lift truck. (2) A work platform may be used to support workers only if other conventional means of access for the task, such as ladders, scaffolds and elevating work platforms, are not practicable. (3) An employer must ensure that a work platform intended for use by workers was designed, and is used by workers, in accordance with (a) ANSI/ITSDF B56.1-2009, Safety Standard for Low Lift and High Lift Trucks, if the platform is being used with a high lift truck as defined in Part IV of that standard, or (b) ANSI/ITSDF B56.6-2011, Safety Standard for Rough Terrain Forklift Trucks, if the platform is being used with a rough terrain forklift truck as defined in section 2 of that standard. (4) The employer must ensure that a work platform intended for use by workers is legibly marked in a conspicuous place to show (a) the name of (i) the manufacturer of the platform, or (ii) the professional engineer who certified the platform as having been built to meet the applicable standard referred to in subsection (3), (b) if the platform was built by a manufacturer, (i) the model number and serial number, or (ii) other unique marking or identification that links the platform with the manufacturer's documentation respecting the platform's design and use, (c) if the platform was custom built, the unique identification number or code that links the platform with the professional engineer's documentation for the platform's design and use, (d) the title of the safety standard or standards the platform was designed to meet, (e) the weight of the platform when the platform is empty, (f) the rated load of the platform, and (g) the minimum width, as measured in accordance with subsection (5), and the minimum rated capacity a lift truck must have to support the platform in a manner that complies with the applicable standard in subsection (3) when the platform is loaded to its rated load. (5) The width of a lift truck referred to in subsection (4) (g) must be measured in a straight line from any point on the outer part of the right load bearing tire to the corresponding point on the outer part of the left load bearing tire. (6) The employer must ensure that a qualified person inspects both the work platform and the lift truck supporting the work platform (a) each time the platform is mounted on the lift truck, and (b) at the start of each work shift, if the platform is already mounted on the lift truck at the start of the work shift, to ensure the platform is properly secured to the lift truck and the lift truck and the platform are safe for use. (7) The employer must ensure that the inspections referred to in subsection (6) take place before either the work platform or the lift truck is used by a worker. (8) Only a worker who is qualified and authorized by the employer may operate a work platform, and the lift truck supporting the work platform, for the purpose of supporting workers on the platform. (9) A worker must not operate either a work platform or the lift truck supporting the work platform unless (a) there is effective two-way voice communication between the lift truck operator and a worker on the platform who is designated by the employer to provide the lift truck operator with directions for platform movement, and (b) the lift truck operator and the designated worker on the platform prearrange hand and arm signals, if the voice communication referred to in paragraph (a) relies on the use of a radio or other electronic system, to allow the designated worker to signal the lift truck operator to bring the platform to the ground or floor level in the event the radio or other electronic system fails. (10) A lift truck operator must remain at the controls of the lift truck at all times there are any workers on the platform supported by the lift truck. (11) Before a work platform may be used to support workers, the lift truck operator must conduct a trial lift of the platform, with no workers on the platform, to assess the suitability of the surface bearing the weight of the lift truck and whether the platform is clear of all obstructions, unless (a) the lift truck is on a type of surface the employer has identified as capable of safely supporting the lift truck and the platform when the platform is loaded to its rated load, and (b) the space in and around which the platform is to be raised is clear of all obstructions.
Read the Occupational Health and Safety Regulation on BC Laws ↗

Made under Workers Compensation Act, RSBC 2019, c. 1.