Occupational Health and Safety Regulation, B.C. Reg. 296/97
Section 12.83.1
Chassis dynamometers — motor vehicle testing
Cite as Occupational Health and Safety Regulation, B.C. Reg. 296/97, s. 12.83.1 · last amended September 1, 2027 · read from BC Laws on November 17, 2026
The text
(1) In this section:
“guard screen” means a screen manufactured from shock-absorbing material and designed to prevent any material striking the screen from ricocheting;
“motor vehicle” means a wheeled vehicle that is propelled by motorized or electric power, but does not include a vehicle that is designed to be used on rails or tracks.
(2) Only a qualified worker may
(a) test a motor vehicle on a chassis dynamometer, or
(b) operate a motor vehicle, chassis dynamometer or other test equipment for the purpose of testing a motor vehicle on a chassis dynamometer.
(3) Before a motor vehicle is tested on a chassis dynamometer, the wheels and tires of the motor vehicle must be inspected by a qualified worker.
(4) A motor vehicle must not be tested on a chassis dynamometer if any of the following apply:
(a) the tires on the motor vehicle contain rocks, stones or other foreign material embedded in the tire treads;
(b) the tires on the motor vehicle are studded;
(c) the wheels or tires on the motor vehicle are incapable of operating safely at the speeds to be reached during testing;
(d) the wheels or tires on the motor vehicle bounce during testing in a manner that is likely to cause the motor vehicle to move laterally off the rolls;
(e) the motor vehicle is likely, without continuous corrective steering, to move laterally off the rolls during testing.
(5) The following safety measures must be taken when testing a motor vehicle on a chassis dynamometer:
(a) the chassis dynamometer must be equipped with front-mounted idler safety rolls unless the motor vehicle is chained or otherwise secured to anchor points to prevent runaways;
(b) wheel chocks must be used to block the non-driving wheels to prevent runaways;
(c) in the case of a motor vehicle with front-wheel drive, the motor vehicle must be prevented from moving laterally during testing;
(d) guard screens of a size that is appropriate for the motor vehicle must be positioned behind the rear of the motor vehicle to block any materials that may be ejected from or by the wheels or tires;
(e) the exposed portions of the moving rolls of the chassis dynamometer must be fitted with adequate guards while the rolls are in motion during testing;
(f) exhaust gases from the motor vehicle must be removed from the work area.
Read the Occupational Health and Safety Regulation on BC Laws ↗
Made under Workers Compensation Act, RSBC 2019, c. 1.