Occupational Health and Safety Regulation, B.C. Reg. 296/97
Section 12.70
Driven-feed chippers
Cite as Occupational Health and Safety Regulation, B.C. Reg. 296/97, s. 12.70 · last amended September 1, 2027 · read from BC Laws on November 17, 2026
The text
(1) A driven-feed chipper must have
(a) a feed table that meets both of the following requirements:
(i) the feed table, including the drop-down extension, if any, must extend at least 150 cm (59 in) from the nip point of the feed rollers;
(ii) the total distance from the nip point of the feed rollers to the ground must be at least 210 cm (82 in), as measured along the centre line of the feed table to the lip of the feed table and then vertically from the lip of the feed table to the ground,
(b) side walls on the feed table, including any drop-down extension, and on the guard chute that are of sufficient height to prevent a worker who is standing on the ground from reaching the feed rollers, and
(c) a feed control bar that is
(i) located across the top and close to the feed end of the guard chute, and
(ii) designed so that a worker endangered by the feed rollers is able to stop or reverse the feed rollers both by
(A) pushing the feed control bar to its forward travel limit, and
(B) pulling the feed control bar to its rearward travel limit.
(2) No part of a person's body may be on the feed table or in the guard chute unless
(a) the feed rollers have stopped, and
(b) the motor of the driven-feed chipper is turned off and locked out.
(3) Despite subsection (1), a driven-feed chipper that is in use in British Columbia before February 1, 2012 may continue to be used if
(a) the driven-feed chipper meets the requirements of subsection (1) (a) and (b),
(b) the feed control bar meets the requirements of subsection (1) (c) (i), and
(c) the feed control bar is designed so that a worker endangered by the feed rollers is able to stop or reverse the feed rollers by at least one of the means set out in subsection (1) (c) (ii).
Read the Occupational Health and Safety Regulation on BC Laws ↗
Made under Workers Compensation Act, RSBC 2019, c. 1.