Subdivision Regulations, B.C. Reg. 262/70

Schedule 2

Appendix B

Cite as Subdivision Regulations, B.C. Reg. 262/70, Schedule 2 · last amended February 24, 2022 · read from BC Laws on November 17, 2026

The text

Appendix B (Sections 6.04 (a) and 6.06) 1 A percolation test shall be made and, depending on the resulting percolation rate, no less area than given below shall be added to the minimum parcel size in section 6.02 or 6.03, as the case may be, of the Subdivision Regulations: Percolation rate (min./inch) Minimum area added to parcel (Sq. Ft.) Less than 5 0 5 and more, but less than 10 500 10 and more, but less than 15 1 000 15 and more, but less than 20 1 500 20 and more, but less than 25 2 000 25 and more, but less than 30 2 500 When the percolation rate is 30 minutes or more, see section 6.04 (b) of the Subdivision Regulations. Percolation tests shall be carried out in accordance with section 6 below. 2 Depending on the slope measured from the uppermost point on the parcel to the lowest point on the parcel, the results obtained in section 1 above shall be increased in accordance with the following: Steepest slope (per cent) Minimum area to be added to parcel (sq. ft.) Less than 10 0 For each 5% or part thereof for 10% and over 500 3 Regardless of the smallest parcel size permitted in accordance with sections 1 and 2 above, the parcel shall contain an area of soil suitable for sewage disposal not smaller than the following, as determined by the percolation rate: Percolation rate (min./inch) Minimum size of area of soil (sq. ft.) Less than 5 1 000 5 and more, but less than 10 1 500 10 and more, but less than 15 2 000 15 and more, but less than 20 2 500 20 and more, but less than 25 3 000 25 and more, but less than 30 3 500 4 There shall be a minimum of 4 feet of natural porous topsoil above the groundwater table in the area of soil referred to in section 3 above, and a representative number of testholes shall be dug in that area to a minimum depth of 4 feet to demonstrate this. 5 The area of soil required for sewage disposal in section 3 above shall be capable of meeting the siting requirements for absorption fields in the Regulations Governing Sewage Disposal. 6 Percolation tests shall be undertaken, as follows: (a) Percolation test holes shall be made at points and elevations selected as typical in the area of the proposed disposal field. (b) One of these test holes shall be dug at each end of the area of the disposal field. Further holes may be required, depending on the nature of the ground and the results of the first test and the size of the proposed field. (c) Test holes are usually drilled using an auger and to the depth of the proposed absorption trench. The standard depth is 24 inches, but the Public Health Inspector may approve or require holes varying from 18 to 32 inches in depth. (d) The soil should be examined as it is removed from the test hole for some indication of its composition and likely percolation rate. (e) To make the percolation test more accurate, any smeared soil should be removed from the walls of the test hole. (f) If the soil contains considerable amounts of silt and (or) clay, the test hole should be presoaked before proceeding with the test. To do this, keep the hole as fully filled with water as possible for 4 hours. Proceed with the test immediately after presoaking. (g) To undertake the test, fill the test hole with water. When the water level is 5 inches or less from the bottom of the hole, refill the hole to a depth of 24 inches or to the top. No recording of time need be done for these 2 fillings. (h) When the water level after the second filling (step (g)) is 5 inches or less from the bottom of the hole, add enough water to bring the depth of water to 6 inches or more. (i) Observe the water level until it drops to the 6 inch depth. At precisely 6 inches, commence timing. When the water level reaches precisely 5 inches depth, stop timing. (j) The time in minutes for the water level to drop 1 inch is the percolation rate for that hole and is recorded in minutes per inch. The percolation rate of the absorption field is the average rate of all the percolation tests made for that field. (k) Backfill the holes with the excavated soil and repeat the test in other locations. Record the results and submit to the local authorities. (l) See section 4.07 of the Subdivision Regulations. NOTE ON SECTION 6 — A percolation test is used to measure the permeability of the soil at the depth of the proposed drainage field. The percolation test will determine the rate, which is a measure of the time in minutes for the water level in a hole to drop 1 inch (from 6 inches from the bottom to 5 inches from the bottom of the hole) and is recorded in minutes per inch.
Read the Subdivision Regulations on BC Laws ↗

Made under Local Services Act, RSBC 1996, c. 276.