Power Engineers, Boiler, Pressure Vessel and Refrigeration Safety Regulation, B.C. Reg. 104/2004
Section 84.1
Registration of control systems
Cite as Power Engineers, Boiler, Pressure Vessel and Refrigeration Safety Regulation, B.C. Reg. 104/2004, s. 84.1 · last amended December 31, 2024 · read from BC Laws on November 17, 2026
The text
(1) In this section, “automated control system” means an automated control system described in section 6 (l) (i) and (ii) and includes the commissioning programs, functional testing programs and maintenance programs for the system.
(2) The design of all automated control systems, including all alterations of previously registered designs, must be registered with a provincial safety manager.
(3) To register a design or an alteration to a design, the owner of the automated control system or the engineer, manufacturer or designer of the automated control system, if the engineer, manufacturer or designer is acting as an agent for the owner, must submit, for review by a provincial safety manager, an application that includes
(a) all design specifications, including information respecting safeguards, controls, interlocks, logic data and system commissioning and testing,
(b) an approval by a professional engineer of the automated control system's design, and
(c) any additional information with respect to the automated control system required by a provincial safety manager.
(4) Registration of a design or an alteration to a design must be obtained before installation is commenced.
(5) If, in the opinion of a provincial safety manager, a design registered under subsection (2) is subsequently found to be defective in any detail,
(a) the provincial safety manager may suspend or revoke the registration,
(b) the design must be revised by the person who submitted the design, and
(c) the automated control system that is the subject of the design must not be installed or used until
(i) those revisions are approved by the provincial safety manager, and
(ii) the provincial safety manager cancels the suspension or reinstates the registration, if the registration was suspended or revoked.
(6) The registration of a design or an alteration to a design does not relieve the professional engineer or equipment manufacturer of liability for the design and the installation of the automated control system.
Read the Power Engineers, Boiler, Pressure Vessel and Refrigeration Safety Regulation on BC Laws ↗
Made under Safety Standards Act, SBC 2003, c. 39.