Coal Mining Occupational Health and Safety Regulations, SOR/90-97

Section 65

Cite as Coal Mining Occupational Health and Safety Regulations, SOR/90-97, s. 65 · current to July 24, 2025 · regulation last amended January 1, 2021

Statute Watch

Get an alert when a bill in Parliament would change this section, and every time it moves.

The text

(1) Every surface hoist shall meet the following standards: (a) the engine shall be installed on a concrete or other rigid foundation; (b) hoisting drums on which the rope is coiled shall be provided with flanges or horns and, where a hoisting drum is conical, with such other safety devices as will prevent the rope from slipping; (c) the hoist shall be equipped with a device that (i) clearly indicates to the hoist operator the location of the cage or trip, and (ii) where a trip may be used on more than one track, is of a type that indicates on which track the trip is being hoisted; (d) the hoist shall be equipped with a braking system that (i) stops cages or trips within the deceleration rates set out in the procedures referred to in subsection 59(1) for both the descending and ascending modes, (ii) is automatically applied in the event of a power failure, and (iii) may be applied by the hoist operator in the event of an emergency; (e) the hoist shall be equipped with an overwind preventor and a speed controller that shut off the power and apply the braking system when the cage or trip travels (i) beyond the top or bottom of the run, or (ii) at a speed in excess of the maximum speed for the cage or trip set out in the procedures referred to in subsection 59(1); (f) unless the overwind preventor and speed controller referred to in paragraph (e) are in full and fixed engagement with the hoisting engine, the overwind preventor and speed controller shall be (i) designed to be fully engaged automatically or by the hoist operator whenever persons are to be transported, and (ii) provided with an automatic device that indicates to the hoist operator and all persons responsible for the loading of the cage or trip that the overwind preventor and speed controller have been fully engaged; and (g) where used for transporting persons, the hoist shall be equipped with at least two brakes that meet the requirements of subparagraphs (d)(i) to (iii). (2) Every device referred to in paragraph (1)(c) shall be tested for effective functioning after every adjustment to the length of the hoist rope.
Read the Coal Mining Occupational Health and Safety Regulations on the Justice Laws Website ↗

Made under Canada Labour Code, R.S.C. 1985, c. L-2.

Bills in Parliament that would change this section 0

No bill we hold would amend or repeal this section.