Multi-Sector Air Pollutants Regulations, SOR/2016-151

Section 71

Sampling ports

Cite as Multi-Sector Air Pollutants Regulations, SOR/2016-151, s. 71 · current to January 19, 2026 · regulation last amended January 1, 2026

Statute Watch

Get an alert when a bill in Parliament would change this section, and every time it moves.

The text

(1) The location of the sampling port, and its traverse points, in the exhaust pipe for each test run must be determined in accordance with (a) EPA Method 1 or EPA Method 1A, as applicable; (b) ASTM D6522-11; or (c) EC Method A. (2) If a pre-existing engine does not have a sampling port that meets the requirements of any of those methods, each test run must (a) be conducted at a single traverse point that is located at the centre of the exhaust pipe at a distance from the engine of at least twice the diameter of that pipe; and (b) have the NOx emission intensity of the engine expressed in ppmvd15%. (3) If an after-treatment control device is used, either (a) the location of the sampling port described by subsection (1) must also be downstream of the device; or (b) for the purpose of paragraph (2)(a), the location of the single traverse point must be downstream of the device — rather than the engine — at a distance from the device of at least twice the diameter of the exhaust pipe.
Read the Multi-Sector Air Pollutants Regulations on the Justice Laws Website ↗

Made under Canadian Environmental Protection Act, 1999, S.C. 1999, c. 33.

Bills in Parliament that would change this section 0

No bill we hold would amend or repeal this section.