Chromium Electroplating, Chromium Anodizing and Reverse Etching Regulations, SOR/2009-162

Section 4

Cite as Chromium Electroplating, Chromium Anodizing and Reverse Etching Regulations, SOR/2009-162, s. 4 · current to July 24, 2025 · regulation last amended March 16, 2020

Statute Watch

Get an alert when a bill in Parliament would change this section, and every time it moves.

The text

(1) Every person that controls the release of hexavalent chromium compounds from a tank by using a point source (a) must use a control device in the emission collection system; and (b) subject to subsection (2), must not release more than 0.03 mg/dscm of hexavalent chromium, if measured separately, or, in any other case, of total chromium, from any point source. (2) If a point source is being used to control the release of hexavalent chromium compounds from a tank located at a facility at which chromium electroplating, chromium anodizing or reverse etching is carried out on the day on which this section comes into force, paragraph (1)(b) applies 30 months after that day.
Read the Chromium Electroplating, Chromium Anodizing and Reverse Etching Regulations on the Justice Laws Website ↗

Made under Canadian Environmental Protection Act, 1999, S.C. 1999, c. 33.

Bills in Parliament that would change this section 0

No bill we hold would amend or repeal this section.