critical defects of commercial motor vehicles, O. Reg. 512/97
Section 7
Cite as critical defects of commercial motor vehicles, O. Reg. 512/97, s. 7 · current to November 11, 2026 · consolidated from March 1, 2022 · read from e-Laws on November 16, 2026
The text
(1) In this section, the measurement of travel of a push rod out of a service brake chamber shall be taken with the vehicle engine turned off, an initial air system pressure between 90 and 100 psi (620 and 690 kPa), the park brakes released and the service brake actuator fully applied. O. Reg. 512/97, s. 7 (1); O. Reg. 166/12, s. 1 (1).
(2) A commercial motor vehicle or trailer, if the trailer is required by subsection 64 (5) of the Act to have brakes, equipped with an air brake system other than an air-over-hydraulic brake system has a critical defect for the purposes of sections 82.1 and 84 of the Act if one or more of the following defects is present on more than 50 per cent of the wheel brakes of the vehicle:
1. A drum or rotor is cracked, broken or missing.
2. A chamber housing, chamber support, chamber push rod, slack adjuster, cam shaft, or cam shaft support bracket is broken or missing.
3. A shoe, shoe lining, shoe block, pad, pad lining or pad block is missing.
4. If the brake is cam or disc type, the push rod travel out of the service brake chamber is ¼ inch (6.3 mm) or more beyond the measurement listed in Column 2 of Schedule 1, 1.1, 1.2, 1.3 or 1.4, as the case may be, for the type of chamber listed in Column 1 of the applicable Schedule.
5. When the brake actuator is applied,
i. there is no movement of the chamber push rod, slack adjuster or cam shaft,
ii. neither one of the two shoes moves, or
iii. neither one of the two shoe linings contacts the drum. O. Reg. 512/97, s. 7 (2); O. Reg. 130/10, s. 5; O. Reg. 166/12, s. 1 (2); O. Reg. 372/17, s. 1.
Read the critical defects of commercial motor vehicles on e-Laws ↗
Made under Highway Traffic Act, R.S.O. 1990, c. H.8.