CONSTRUCTION PROJECTS, O. Reg. 213/91

Section 307

Cite as CONSTRUCTION PROJECTS, O. Reg. 213/91, s. 307 · current to November 11, 2026 · consolidated from April 20, 2026 · read from e-Laws on November 16, 2026

The text

(1) Except for a tunnel cut in sound rock, the sides and roof of a tunnel shall be supported by timbers set on ribs or beams or by an equivalent system of lining. O. Reg. 213/91, s. 307 (1). (2) If a tunnel is to be cut in sound rock, the constructor shall obtain a written opinion from an engineer as to whether the sides and roof of the tunnel need to be supported by rock bolts or wire mesh to prevent the spalling of loose rock. O. Reg. 213/91, s. 307 (2); O. Reg. 375/22, s. 5. (3) The sides and roof of a tunnel cut in sound rock, (a) shall be supported, where necessary in the opinion of the engineer, by rock bolts or wire mesh; (b) shall be inspected daily by a competent worker; and (c) shall have all loose pieces of rock removed. O. Reg. 213/91, s. 307 (3); O. Reg. 375/22, s. 5. (4) If the permanent lining of a tunnel will, when completed, consist of a primary lining and a secondary lining, the primary lining shall be strong enough to support the sides and roof of the tunnel until the secondary lining is installed. O. Reg. 213/91, s. 307 (4). (5) If the permanent lining of a tunnel consists only of a concrete cast-in-place lining, the tunnel shall not be excavated beyond the leading edge of the permanent lining unless adequate temporary shoring is installed as soon as is practicable. O. Reg. 213/91, s. 307 (5). (6) The primary supports of a tunnel, (a) shall be designed by an engineer in accordance with good engineering practice to withstand all loads likely to be applied to them; and (b) shall be constructed in accordance with the design. O. Reg. 213/91, s. 307 (6); O. Reg. 375/22, s. 5. (7) The constructor shall keep available for inspection at a project the design drawings for the primary supports. O. Reg. 213/91, s. 307 (7); O. Reg. 85/04, s. 23.
Read the CONSTRUCTION PROJECTS on e-Laws ↗

Made under Occupational Health and Safety Act, R.S.O. 1990, c. O.1.