CONSTRUCTION PROJECTS, O. Reg. 213/91

Section 26.9

Cite as CONSTRUCTION PROJECTS, O. Reg. 213/91, s. 26.9 · current to November 11, 2026 · consolidated from April 20, 2026 · read from e-Laws on November 16, 2026

The text

(1) This section applies to a lanyard or lifeline that is part of a travel restraint system or a fall arrest system. O. Reg. 145/00, s. 14. (2) The following requirements apply to a lanyard or a lifeline: 1. It shall not be used in such a way that it is likely to be cut, chafed or abraded. 2. It shall not be subjected to extreme temperature, flame, abrasive or corrosive materials or other hazards that may damage it. 3. The free end of the lanyard or lifeline shall be kept clear of equipment and machinery. O. Reg. 145/00, s. 14. (3) Only one person at a time may use a lanyard. O. Reg. 145/00, s. 14. (4) The connecting ends of a lanyard shall be wrapped around a protective thimble and adequately fastened with a swaged fitting or eye splice supplied by the manufacturer of the lanyard. O. Reg. 145/00, s. 14; O. Reg. 242/16, s. 5. (5) A horizontal or vertical lifeline shall be kept free from splices or knots, except knots used to connect it to a fixed support. O. Reg. 145/00, s. 14. (6) Only one person at a time may use a vertical lifeline. O. Reg. 145/00, s. 14. (7) A vertical lifeline shall, (a) extend to the ground; or (b) have a positive stop that prevents the rope grab or other similar device from running off the end of the lifeline. O. Reg. 145/00, s. 14. (8) The following requirements apply to a horizontal lifeline system: 1. It shall be designed by an engineer in accordance with good engineering practice. 2. The design may be a standard design or a custom design. 3. The design shall, i. show the arrangement of the system including the anchorage or fixed support system, ii. indicate the components used, iii. state the number of workers that can safely be attached to it, iv. set out instructions for installation or erection, and v. show the design loads for the system. 4. The system shall be installed or erected, and maintained, in accordance with the engineer’s design. 5. Before each use, the system shall be inspected by an engineer or a competent worker designated by a supervisor. 6. The constructor shall keep the design at the project while the system is in use. O. Reg. 145/00, s. 14; O. Reg. 375/22, s. 4, 5. 26.10, 26.11 Revoked: O. Reg. 85/04, s. 10.
Read the CONSTRUCTION PROJECTS on e-Laws ↗

Made under Occupational Health and Safety Act, R.S.O. 1990, c. O.1.