CONSTRUCTION PROJECTS, O. Reg. 213/91
Section 26.5
Cite as CONSTRUCTION PROJECTS, O. Reg. 213/91, s. 26.5 · current to November 11, 2026 · consolidated from April 20, 2026 · read from e-Laws on November 16, 2026
The text
(1) A fall restricting system that is not designed for use in wood pole climbing shall consist of an assembly of components that is,
(a) attached to an independent fixed support that meets the requirements of section 26.7; and
(b) designed and arranged in accordance with the manufacturer’s instructions and so that a worker’s free fall distance does not exceed 0.6 metres. O. Reg. 85/04, s. 6.
(2) A fall restricting system that is designed for use in wood pole climbing,
(a) shall consist of an assembly of components that is designed and arranged in accordance with the manufacturer’s instructions; and
(b) shall not allow pole slippage in excess of the distances set out in the applicable National Standards of Canada standard referred to in subsection 26.1 (3). O. Reg. 85/04, s. 6.
(3) A fall restricting system shall be inspected by a competent worker before each use. O. Reg. 85/04, s. 6.
(4) If a component of the fall restricting system is found to be defective on inspection, the component shall be taken out of service immediately. O. Reg. 85/04, s. 6.
(5) If a worker who is using the fall restricting system falls or slips more than the distance determined under clause (1) (b) or (2) (b), as the case may be, the system shall be taken out of service immediately and shall not be used again by a worker unless all components of the system have been certified by the manufacturer as being safe for reuse. O. Reg. 85/04, s. 6.
Read the CONSTRUCTION PROJECTS on e-Laws ↗
Made under Occupational Health and Safety Act, R.S.O. 1990, c. O.1.