CONSTRUCTION PROJECTS, O. Reg. 213/91
Section 22
Cite as CONSTRUCTION PROJECTS, O. Reg. 213/91, s. 22 · current to November 11, 2026 · consolidated from April 20, 2026 · read from e-Laws on November 16, 2026
The text
(1) Every worker shall wear protective headwear at all times when on a project. O. Reg. 213/91, s. 22 (1).
(2) Protective headwear shall be a safety hat that,
(a) consists of a shell and suspension that is adequate to protect a person’s head against impact and against flying or falling small objects; and
(b) has a shell which can withstand a dielectric strength test at 20,000 volts phase to ground. O. Reg. 213/91, s. 22 (2).
(c) satisfies the requirements set out in,
(i) subsection (3), if the worker may be exposed to side impact hazards when on the project, or
(ii) subsection (4), if subclause (i) does not apply.
(3) For the purposes of subclause (2) (c) (i), the protective headwear shall satisfy one of the following requirements:
1. It shall be manufactured in accordance with and meet the design, performance and test requirements of Type 2 protective headwear in the CSA Standard Z94.1, Industrial protective headwear — Performance, selection, care and use or Type II protective headwear in the ANSI Z89.1 Standard, American National Standard for Industrial Head Protection.
2. It shall provide protection that is at least equal to that provided by protective headwear that meets the requirement set out in paragraph 1. O. Reg. 112/26, s. 1 (2).
(4) For the purposes of subclause (2) (c) (ii), the protective headwear shall satisfy one of the following requirements:
1. It shall be manufactured in accordance with and meet the design, performance and test requirements of protective headwear in the CSA Standard Z94.1, Industrial protective headwear — Performance, selection, care and use or the ANSI Z89.1 Standard, American National Standard for Industrial Head Protection.
2. It shall provide protection that is at least equal to that provided by protective headwear that meets the requirement set out in paragraph 1. O. Reg. 112/26, s. 1 (2).
(5) If the conditions on a project may cause protective headwear worn by a worker to dislodge, a chin strap or other retention system shall be used to prevent dislodgement. O. Reg. 112/26, s. 1 (2).
Read the CONSTRUCTION PROJECTS on e-Laws ↗
Made under Occupational Health and Safety Act, R.S.O. 1990, c. O.1.