CONSTRUCTION PROJECTS, O. Reg. 213/91

Section 163

Cite as CONSTRUCTION PROJECTS, O. Reg. 213/91, s. 163 · current to November 11, 2026 · consolidated from April 20, 2026 · read from e-Laws on November 16, 2026

The text

(1) Subject to subsection (2), the operator’s cabin of a tower crane shall be located on and attached to or positioned on the crane in accordance with the instructions of the crane’s manufacturer for the specific model and configuration of the crane and in such a manner that in the event of a failure of the boom, the cabin will not be crushed against the mast. O. Reg. 213/91, s. 163 (1). (2) The operator’s cabin shall not be located on or attached to the boom unless, (a) the cabin and its attachments have been specifically designed and fabricated for that purpose by the original manufacturer of the crane in accordance with good engineering practice; (b) the boom of the crane cannot affect or be affected by the operation of another crane or make contact with a structure or equipment; (c) the crane is not overlapped by any part of another crane; (d) because of specific site conditions, the location of the cabin on the boom provides greater visibility for the operator than does the manufacturer’s standard cabin location; (e) the means of access to the cabin or other locations on the boom is by a catwalk constructed of skid resistant expanded metal or similar material and fitted with solidly constructed guardrails and devices which provide fall protection for the operator; (f) the structural, environmental and ergonomic design of the cabin is equal to or greater than that of the crane’s manufacturer’s standard cabin design; and (g) the proposed location and attachment method provide a structural and mechanical safety factor equal to or greater than that of a cabin located on the crane mast or attached to the slewing ring. O. Reg. 213/91, s. 163 (2). (3) If the crane manufacturer specifies the location of the operator’s cabin to be on the boom of a tower crane, the crane manufacturer shall provide to the owner of the crane a report for the specific model and specific configuration of crane on a project. O. Reg. 213/91, s. 163 (3). (4) The crane manufacturer’s report shall include, (a) the crane load restrictions, reductions or modifications resulting from the effect of the cabin weight and its offset from the boom centreline; (b) the crane configuration and operating restrictions resulting from the effect of the cabin location and attachment method; and (c) engineering design drawings that include, (i) the structural and ergonomic design of the cabin, (ii) the location of the cabin on the boom, (iii) the attachment method including all fittings and hardware, and (iv) all means of access. O. Reg. 213/91, s. 163 (4).
Read the CONSTRUCTION PROJECTS on e-Laws ↗

Made under Occupational Health and Safety Act, R.S.O. 1990, c. O.1.