ROLL-OVER PROTECTIVE STRUCTURES, R.R.O. 1990, Reg. 856

Section 5

Cite as ROLL-OVER PROTECTIVE STRUCTURES, R.R.O. 1990, Reg. 856, s. 5 · current to November 11, 2026 · consolidated from July 1, 2022 · read from e-Laws on November 16, 2026

The text

(1) Every roll-over protective structure, (a) shall be designed, constructed and maintained so that, when the machine to which it is fastened is travelling at a forward speed of 16 kilometres per hour, engages a thirty degree slope and rolls 360 degrees about its longitudinal axis on a hard clay surface, (i) the roll-over protective structure will withstand the impact forces, (ii) upon impact, no part of the roll-over protective structure will enter the space of the machine that is normally occupied by its operator, and (iii) the roll-over protective structure will support the machine in an upside-down attitude without any part of the roll-over protective structure entering the space of the machine that is normally occupied by its operator; (b) shall bear a legible label indicating, (i) the name and address of the manufacturer of the roll-over protective structure or, if it is custom built, the name and address of the engineer referred to in subsection (2), and (ii) the make, model and maximum mass of the machine that the roll-over protective structure is designed to fit; (c) shall be securely fastened to the frame of the machine; and (d) shall be capable of withstanding all forces to which it is likely to be subjected. R.R.O. 1990, Reg. 856, s. 5 (1); O. Reg. 371/22, s. 2 (1). (2) Every custom built roll-over protective structure, every repair to such a structure and every custom built modification to a roll-over protective structure shall be certified as meeting the requirements of clause (1) (a) by an engineer. R.R.O. 1990, Reg. 856, s. 5 (2); O. Reg. 371/22, s. 2 (2). (3) Every repair to a roll-over protective structure other than a custom built structure shall be approved by the manufacturer of the structure as meeting the requirements of clause (1) (a). R.R.O. 1990, Reg. 856, s. 5 (3).
Read the ROLL-OVER PROTECTIVE STRUCTURES on e-Laws ↗

Made under Occupational Health and Safety Act, R.S.O. 1990, c. O.1.