MINES AND MINING PLANTS, R.R.O. 1990, Reg. 854

Section 229

Cite as MINES AND MINING PLANTS, R.R.O. 1990, Reg. 854, s. 229 · current to November 11, 2026 · consolidated from July 1, 2025 · read from e-Laws on November 16, 2026

The text

(1) Shaft ropes shall be attached by closed type devices that will not inadvertently disconnect. R.R.O. 1990, Reg. 854, s. 229 (1). (2) In a drum hoist installation, the hoisting rope from a shaft conveyance and counterweight shall be attached to the drum of the hoist. R.R.O. 1990, Reg. 854, s. 229 (2). (3) No wedge type attachments shall be used unless the attachments are, (a) in sound condition; and (b) certified at least once every six years of use as meeting the manufacturer’s specifications by a competent person or by the manufacturer. R.R.O. 1990, Reg. 854, s. 229 (3); O. Reg. 187/19, s. 16. (4) When the attachments for a shaft hoisting rope are first installed, or re-installed after disassembling, the following measures and procedures shall be taken before the hoist is put to use: 1. Two test trips of the conveyance or counterweight through the working part of the shaft, while the conveyance or counterweight is carrying normal load shall be performed. 2. An examination of the attachments upon the completion of the two test trips shall be made. 3. Any necessary adjustments shall be made. 4. A record of any adjustments, examinations and test trips shall be made in the Hoisting Machinery Record Book by the person or persons making the adjustments, examinations and test trips. R.R.O. 1990, Reg. 854, s. 229 (4). (5) Where shaft rope attachments are made using rope clips, the number of clips to be used and their torque shall be in accordance with good engineering standards. R.R.O. 1990, Reg. 854, s. 229 (5). (6) A socket attachment used between a shaft conveyance or counterweight and a shaft rope shall be, (a) designed to be suitable for mine hoisting; (b) installed by a person who, (i) is competent in the installation of the type of socket being used, and (ii) complies with the manufacturer’s current installation standard; and (c) if it is used for hoisting ropes, made with a socket long enough to ensure that the embedded length of rope in the socket is greater than seven times the rope diameter. O. Reg. 486/99, s. 14; O. Reg. 84/07, s. 16. (7) Each component of an attachment between a shaft conveyance or counterweight and a shaft rope, except for a rope clip, shall be designed to ensure that when in service and carrying the rated load, the component is capable of withstanding at least four times the maximum allowable design stresses without permanent distortion. O. Reg. 486/99, s. 14. (8) For the purpose of subsection (7), the maximum allowable design stresses are those established by good engineering practice and shall take into account the effects of, (a) the weight of the conveyance or counterweight; (b) the rated load; (c) any impact load; (d) any dynamic load; (e) stress concentration factors; (f) corrosion; (g) metal fatigue; and (h) dissimilar materials. O. Reg. 486/99, s. 14. (9) The rope attachments, other than rope clips, installed after October 7, 1999 shall be identified and load rated by the manufacturer or an engineer. O. Reg. 486/99, s. 14; O. Reg. 373/22, s. 16.
Read the MINES AND MINING PLANTS on e-Laws ↗

Made under Occupational Health and Safety Act, R.S.O. 1990, c. O.1.