MINES AND MINING PLANTS, R.R.O. 1990, Reg. 854

Section 22

Cite as MINES AND MINING PLANTS, R.R.O. 1990, Reg. 854, s. 22 · current to November 11, 2026 · consolidated from July 1, 2025 · read from e-Laws on November 16, 2026

The text

(1) For the purpose of subsection 29 (2) of the Act, drawings, plans and specifications to be kept and maintained shall be, (a) a surface plan showing, (i) the boundaries of a mining property, (ii) the co-ordinates of the section of a mining property under which mining has been done, (iii) all lakes, streams, roads, railways, electric power transmission lines, main pipe lines, buildings, adits, surface workings, diamond drill holes, out-croppings of rock, dumps, tailing-disposal sites and openings to an underground mine, and (iv) stopping of openings on the surface to an underground mine; (b) plans on a horizontal plane with separate drawings for each level showing all underground workings, including shafts, tunnels, diamond drill holes, dams and bulkheads; (c) plans on a vertical plane of all mine sections at suitable intervals and azimuths, showing all shafts, tunnels, drifts, stopes and other mine workings in relation to the surface, including the location of the top of the bedrock, the surface of the overburden and the bottom and surface of any known watercourse or body of water; and (d) a plan or diagram showing, (i) the position of all fixed electrical apparatus and communication systems in the mine, (ii) the routes of all fixed power feeders and fixed branch feeders properly noted and referenced, and (iii) the rating of all electrical feeder control apparatus and equipment. R.R.O. 1990, Reg. 854, s. 22 (1). (2) The surface plan prescribed by clause (1) (a) shall show, (a) the boundaries of the mining property, (i) related to the lot fabric where the property is in a subdivided township, (ii) connected to the nearest mile post on a surveyed township boundary where the property is in an unsubdivided township, or (iii) connected to the nearest, (A) mile post on a surveyed township boundary, (B) base line, or (C) meridian line, where the property is in unsurveyed territory, and (iv) connected to a co-ordinate control survey monument if one exists within ten kilometres of the property; and (b) the position and form of a permanent bench mark to which all elevations are related, and the permanent bench mark shall be related, (i) where a Canadian Geodetic Datum bench mark exists within ten kilometres, to that bench mark, and (ii) to the permanent bench mark of each adjoining property. R.R.O. 1990, Reg. 854, s. 22 (2). (3) The measurements under clause (2) (a) shall be consistent with accuracy standards for third order horizontal control surveys based on Ontario Specifications for Horizontal Control Surveys, 1979. R.R.O. 1990, Reg. 854, s. 22 (3). (4), (5) Revoked: O. Reg. 187/19, s. 8.
Read the MINES AND MINING PLANTS on e-Laws ↗

Made under Occupational Health and Safety Act, R.S.O. 1990, c. O.1.